Operation Manual

128
User Manual
Note
Pressing 'CLEAR' hides the Depth Cursor and if the Fish Finder is in Auto Range or Bottom Lock
mode switches into Bottom Lock Zoom mode.
6.5 FISH FINDER SETUP MENU
The Fish Finder Setup menu provides access to additional functions, setup
and layout/data field options. From the Fish Finder page, access this menu by pressing:
'MENU'
Fig. 6.5 - The Fish Finder Setup menu
6.5.1 PRESET MODE
Preset modes are pre-defined settings of the Fish Finder operating parameters.
You can use them to quickly set the Fish Finder in the most commonly used operating
modes. These are Cruise (sets the Fish Finder in full auto mode with the sensitivity
settings optimized for displaying at best the bottom) and Fish (sets the Fish Finder in
full auto mode with the sensitivity setting optimized for target searching). See the
following table.
'MENU' + "PRESET MODE" + 'ENTER'
• Fish
Gain Mode = Auto, Range Mode = Auto, Frequency = do not change, Shift
= 0, STC = Short if Freq=200kHz and Mid if Freq=50kHz, Scrolling Speed
= 10, Fish Symbols = Echo, A-Scope = On, Surface Noise Filter = Off.
• Cruise
Gain Mode = Auto, Range Mode = Auto, Frequency = do not change, Shift
= 0, STC = Short if Freq=200kHz and Mid if Freq=50kHz, Scrolling Speed
= 10, Fish Symbols = Echo, A-Scope = On, Surface Noise Filter = 4.