Operation Manual

133
User Manual
6.5.12 ALARMS
The Alarms menu allows you to define additional sonar alarm settings for
Fish Alarm, Shallow Alarm, Depth Alarm and Temperature Upper/Lower/Rate.
'MENU' + "ALARMS" + 'ENTER'
6.5.12.1 Shallow Alarm
Triggers an alarm when depth becomes shallower than the value set.
6.5.12.2 Deep Water Alarm
Triggers an alarm when depth becomes deeper than the value set.
6.5.12.3 Temp Upper
Triggers an alarm when the transducer reports a temperature (from TEMP 1
sensor) above the value set.
6.5.12.4 Temp Lower
Triggers an alarm when the transducer reports a temperature (from TEMP 1
sensor) below the value set.
6.5.12.5 Temp Rate
Triggers an alarm when the transducer reports a temperature (from TEMP 1
sensor) variation rate above the value set.
6.5.12.6 Fish Alarm
The options for Fish Alarm set the size of the fishes that, if detected by the
unit, switches an alarm to sound. These options are: Off, Small, Medium, Big and
Huge. The alarm sounds if the set size (or bigger) is detected.
6.5.13 LOAD SETTINGS FROM USER C-CARD
Load the complete settings from the User C-CARD and changes the active
menu settings. Insert the User C-CARD into the slot, then follow the procedure:
'MENU' + "LOAD SETTINGS FROM USER C-CARD" + 'ENTER'
6.5.14 SAVE SETTINGS TO USER C-CARD
This is useful to avoid the user having to retune up Fish Finder after a Clear
RAM operation or a software update.