Operation Manual

145
User Manual


 C-CARD Connector
Indicates if there is a malfunction in the connector. It is used only in production.
7.6.4 SERIAL PORTS
If you are having problems receiving data from the position-finding
instrument, this test should help determine the problem.


 Change Parameters
Allows to change the parameters of the serial interface. This menu allows to
select the Port (Signal Source), the Baud Rate between 4800 or 9600, the Data
Bits (Word Length) between 7 or 8, the Parity between even, odd or none, the
Stop Bits between 1 or 2. Default settings are: Port = Port 1, Baud Rate = 4800,
Data Bits = 8, Parity = none, Stop Bits = 1.


 Input Data Display
Allows the chart plotter to act as a computer terminal and display the incoming
data exactly as it received.
If the data displayed on the screen is unrecognizable, you may have selected the
wrong input parameters for your particular receiver. Check your receiver manual
to be sure that you have selected the proper interface format. If the screen is
blank, you may have a broken connection and no data is being received.
Use 'ZOOM IN' to stop (or continue after pause) data displaying, 'ENTER' to
show data in hex or ASCII mode (normal or small) and 'CLEAR' to exit.
7.6.5 MODEM TEST
To check the Modem connections. Press 'ENTER' to select the preferred
Port related to the connections made, to the Port that the Modem C-COM is con-
nected.