Operation Manual

31
User Manual
3
For the New User
In order to get started using your chart plotter, you must do the following
things:
1) Your chart plotter must have been installed properly according to the
installation instruction on Par. 6.2.
2) You must have performed the proper settings for use with your position-
ing instrument (see Par. 2.5) and inserting the C-CARD for navigating in area you
wish (see Par. 2.6).
3) You must have turned on the chart plotter and adjust the brightness and
contrast of the display (see Par. 2.2 and 2.3).
Once this is done, you can use your chart plotter for navigation.
3.1 SCREEN DISPLAY CONFIGURATION
Use 'PAGE' to select the desired page, in two different ways:
1) by showing the next page as the relative key is pressed
2) by selecting the page from the Page Selection menu
The desired way to select the page is set by changing "Page Preview" following
the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "PAGE PREVIEW" + 'ENTER'
When "Page Preview" is "Off", 'PAGE' allows setting the next page (1). When
"Page Preview" is "On", 'PAGE' opens the Page Selection menu (2), on which the
icons representing the pages are shown: the icon of the currently selected page is
identified by a bold frame; move the selection with the Cursor keys or 'PAGE', the
name of the currently selected page icon is shown in the lower side of the Page
Selection menu. Pressing 'ENTER' the Page Selection menu is closed and the currently
selected page is activated.