Operation Manual

User Manual

3.5.1.11 Selecting the Chart Language

'MENU' + "MAP SETTINGS" +'ENTER' + "Chart Language" + 'ENTER'

The possible choices are:

Language: Allows setting the language to display chart information. The language is

chosen among the list of languages available on the cartographic data (C-CARD or

embedded charts).

'MENU' + "MAP SETTINGS" +'ENTER' + "Chart Language" + 'ENTER' + "Lan-

guage" + 'ENTER'

Mode: Defines how objects are translated. It is possible to choose between the three

following options:

• OFF : Uses the same Language used for LANGUAGE. If the se-

lected language is not present on the objects information,

English is used instead.

• ENGLISH : Always uses English.

• LOCAL : Uses the first Local language present on data. If no Local lan-

guage is available, English is used instead.

'MENU' + "MAP SETTINGS" +'ENTER' + "Chart Language" + 'ENTER' + "Mode"

+ 'ENTER'

Note

a. When User Interface Language is changed, Chart Language settings are set as follows:

MODE is set to Off and Chart Language is set as the User Interface Language selection

if available on the chart data, otherwise is set to English.

b. If the cartographic data is changed (for example the C-CARD is removed or replaced),

Chart Language settings should be verified and if necessary changed.

3.5.1.12 Other Map Configurations

'MENU' + "MAP SETTINGS" +'ENTER' + "Other Map Configurations" + 'ENTER'

This function allows the user to customize the following selections and is

divided into the following setting: Marine Settings, Depth Settings, Land Settings,

Underwater Objects Settings and Chart Settings.

Display Mode: To simplify the customization of the chart display, the map settings

are now re-organized in modes allowing the user to choose the preferred setting. Pre-

programmed settings are user selectable from Full, Medium, Low, Radar, Tides,

Custom. The default setting is Custom.

'MENU' + "MAP SETTINGS" +'ENTER' + "Other Map Configurations" + 'ENTER'

+ "Display Mode" + 'ENTER'

The table below shows the selections for each mode: