Operation Manual

User Manual

Fig. 4.1.1.5 - Selecting destination (Target)

The destination will automatically switch to the next Waypoint on the route

when you reach or pass the present destination.

Time To Go

When the Target is set the TTG value is displayed in the Graphic Data page:

'PAGE' more times to select Graphic Data page

Note

If SOG value is less than 1.0 knots or the BRG is greater than 90 degrees, the TTg value is not

displayed.

Deleting Target

If in Basic Mode place cursor on Target icon and press 'CLEAR': the symbol that

identifies Target disappears from the screen, but the Waypoint remains.

If in Advanced Mode (see Par. 3.4.3) place cursor on Target icon, press 'ENTER',

select "STOP NAV" and press 'ENTER': the symbol that identifies Target disap-

pears from the screen, but the Waypoint remains.

Note

If you select "NEXT"/"PREV" and press 'ENTER', the Target icon is moved on the next/

previous Waypoint in the route.

Otherwise in both Modes (when the cursor is placed in a generic position on the

chart) press 'GO-TO'. A window appears to advice that the Destination point is

present: select "STOP" and press 'ENTER', the symbol that identifies Target

disappears from the screen, but the Waypoint remains.

Note

If you select "START" and press 'ENTER', the Target icon is moved on the new cursor position.