Operation Manual

User Manual

If any of these alarm conditions is detected, the function returns the list of dangerous

objects and the relative dangerous route leg, that is drawn with a different color.

To activate this function:

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' + "AU-

TOMATIC CHECK" + 'ENTER' + "ON" + 'ENTER'

Note

If Automatic Check is enabled, anytime you append or insert a new Waypoint, delete, move or

edit any Waypoint, the Route is checked. Only the modified Route legs are checked.

To select the width of the detected area aside the route:

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +

"ROUTE WIDTH" + 'ENTER'

Note

Safe Route width value represents half the total width checked by the function.

To select the depth of the detected area aside the route:

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +

"ROUTE DEPTH" + 'ENTER'

It also possible to select the accuracy for the route check, among Very Low,

Low, Medium, High and Very High:

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' + "AC-

CURACY" + 'ENTER'

The list of the dangerous objects found on the charts crossed by the route is

shown in the route check report, follow the procedure:

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +

"ROUTE CHECK REPORT" + 'ENTER'

4.2 MARK & EVENT

You may place a Mark, as it is called, at your cursor position, while Event is

created at your vessel position.

4.2.1 MARKS

You may tag a location on the chart with a Mark symbol and number, which

you can record for later use. Every time you place the cursor on a Mark the following

functions are available.