Operation Manual

89
User Manual
MOB handling
If the navigation to the external destination is active and 'MOB' is pressed on the
Slave chart plotter, the MOB is placed but the navigation to the MOB is not acti-
vated.
Notes
While navigating to the external destination the operating mode is switched to Mas-
ter mode, the navigation to the external destination will be terminated. An appropri-
ate warning message will be shown to notify that the navigation to the external
destination is active and to confirm whether Slave mode can be set. Setting Slave
mode, the C-Link Navigation Data will be deleted.
The C-Link Navigation Data are deleted at Power Off.
4.8.1.5 C-Link Navigation Data: acquisition and display
As soon as the C-Link Navigation Data is received, the Slave parses the informa-
tion received and executes the relative actions depending on its current working status.
Important
When the navigation to the external destination is activated, the Slave chart plotter will show all
relevant C-Link Navigation Data exactly like when the destination is not the external one:
(Destination Name, DST and BRG to Destination, calculate XTE, calculate TTG etc.). These values
will be displayed all places where required and they will be used to format NMEA-0183 output data.
4.8.1.6 Graphical representation on Map Display
Fig. 4.8.1.6 - Graphical Displaying
4.8.1.7 Route Data Report
When the navigation to the External Route is received, it will be possible to display the
information related to the External Route by entering the Route Data Report.