Operation Manual

28
User Manual
P ANORAMIC /C OMPACT 8 HD
1. Connect AUX IN I/O as follows:
AUXINI/O
AUX-IN I/O CABLE
AUX-IN I/O CABLE
1
2
3
4
5
6
7
8
PIN CABLE COLOR FUNCTION
BLACK
RED
WHITE
GREEN
GRAY
YELLOW
BROWN
BLUE
GND/COMMON
POWER OUTPUT+
Used by C-COM
Used by C-COM
OUTPUT 5+
Used by C-COM
INPUT 5+
OUTPUT EXTERNAL ALARM+
(10-35 Vdc)
Fig. 2.5.4 - Connection for the Port 4
Note
The connection is valid for the C-COM IR and C-COM RS232 too.
2. Set the C-COM for Port 4 as follows:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 4 INPUT" + 'ENTER' + "C-COM" + 'ENTER'
Also the modem C-COM can be connected to the other ports, in this case set
the format for the selected port.
P ANORAMIC /C OMPACT 8 XL
P ANORAMIC /C OMPACT 8 HD IF P ORT 4 OF AUX IN I/O CONNECTOR IS BUSY
P ANORAMIC /C OMPACT 8 HD F ISH
1. Cut the C-COM cable about 5 cm from the "T" connector:
Fig. 2.5.4a - C-COM cable
2. Connect the wires to the quick disconnect bracket cable as follows:
QUICK DISCONNECT BRACKET CABLE
DESCRIPTIONWIRE COLOR
BLACK
RED
WHITE
GREEN
YELLOW
POWER SUPPLY GND
POWER SUPPLY+
C-COM
SIGNAL RETURN
C-COM
POWER GND
POWER +10-35Vdc
INPUT1+
SIGNAL RETURN-
OUTPUT1+
FUNCTION
C-COM GSM Plus CABLE
WIRE COLOR
BLACK
RED
WHITE
GREEN
YELLOW
GND
POWER SUPPLY+
C-COM TX+
C-COM TX-
C-COM RX+
FUNCTION
Fig. 2.5.4b - Connection for the Port 1
Note
The connection is valid for the C-COM IR and C-COM RS232 too.