Operation Manual
42
User Manual
nal Alarm (when activated, this pin goes to GND level. It is used to command an
external buzzer), External Power (it is command switch for the Radar. It must be
used in conjunction with the Radar Junction box device) and Off.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"EXTERNAL SIGNAL" + 'ENTER'
3.2.8.8 Cable Wiring Page
Shows a window containing the inteface cable wiring. See Par. 6.3 and 6.4.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"CABLE WIRING" + 'ENTER'
3.2.8.9 Fish Finder Transmission F
OR
P
ANORAMIC
8 HD F
ISH
& C
OMPACT
8 HD F
ISH
The Fish Finderinternal is connected directly to the Port 2. To switch the
internal Fish Finder transmission On/Off follow the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"FISH FINDER + 'ENTER'
3.2.9 C-VOICE MENU
AVAILABLE ONLY IF THE CHART PLOTTER IS CONNECTED TO VOICE NAVIGATION SYSTEM
The chart plotter has two different vocal modes, Navigation and Echosounder.
According to what mode is selected the messages spoken from the chart plotter are
different.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER'
3.2.9.1 Navigation
Enables (On), disables (Off) or insert the time (2, 5, 10, 15 minutes) for the
Navigation Voice mode. If it is On, the message is always sent, as fast as possible.
Instead if it is one among the available values, for example 2 minutes, the message is
sent related to the selected time, in the previous example every two minutes.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER' +
"NAVIGATION" + 'ENTER'
3.2.9.2 Echosounder
Enables (On) or disables (Off) the Echosounder Voice mode. If it is On, the
Depth message is spoken. The message is spoken if a valid depth data is received by
the chart plotter or if it is in Simulation mode. The default setting is Off.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER' +
"ECHOSOUNDER" + 'ENTER'
3.2.9.3 Output Port
Selects the Output Port for the Voice function. The default setting is Port 1.