Operation Manual

User Manual

5.3.4 MAP ORIENTATION RESOLUTION

Selects the orientation of your chart according to your personal needs (see

Par. 3.5.1.3 for more information).

The Orientation Resolution is the resolution angle for the Map Orientation,

range [5°, 60°]. The default setting is 30°.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "NAVIGATE" + 'ENTER' +

"ORIENT. RESOLUTION" + 'ENTER'

5.3.5 ROLLING ROAD SCALE

Sets you preferred Rolling Road Scale among 0.2, 0.5, 1.0, 2.0, 4.0, 10.0. The

default setting is 0.2.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "NAVIGATE" + 'ENTER' +

"ROLL ROAD SCALE" + 'ENTER'

5.3.6 RESET PARTIAL AND TOTAL TRIP

Resets the partial and total distance traveled by the ship from the first activa-

tion of the chart plotter or starting from the values reset. The partial and total trip

value is shown on the top of the Navigation Page.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "NAVIGATE" + 'ENTER' +

"RESET PARTIAL TRIP" + 'ENTER'

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "NAVIGATE" + 'ENTER' +

"RESET TOTAL TRIP" + 'ENTER'

5.3.7 SELECTABLE NAV 3D

If the "Selectable Nav 3D" item is set ON, by pressing '<MODE>' it is possi-

ble to select the following modes: Charting, Navigation (Home), Navigation (Home) in

3D, Charting in 3D. Any time the key is pressed, a message describing the newly se-

lected mode is shown on the center of the screen for about 2 seconds.

If the "Selectable Nav 3D" item is set OFF, by pressing '<MODE>' it is

possible to select Charting or Navigation (Home). The default setting is Off.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "NAVIGATE" + 'ENTER' +

"SELECTABLE NAV 3D" + 'ENTER'

5.4 COMPASS

The Compass menu sets the desired value for Bearing and Magnetic Varia-

tion, and selects the Calibration Page.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "COMPASS" + 'ENTER'