Operation Manual

User Manual

5.7.2.2 Activation range

'MENU' + "AIS SETUP" + 'ENTER' + "ACTIVATION RANGE" + 'ENTER'

Defines the range from the fix within which the AIS Target becomes active.

The values allowed are from 0.1 to 20 Nm. The default setting is 5 Nm.

5.7.2.3 CPA Alarm

'MENU' + "AIS SETUP" + 'ENTER'+ "CPA ALARM" + 'ENTER'

Turns ON or OFF the alarm. The default setting is ON.

5.7.2.4 CPA Limit

'MENU' + "AIS SETUP" + 'ENTER' + "CPA LIMIT" + 'ENTER'

The values allowed are from 0.1 to 10 Nm. The default setting is 0.5 Nm.

5.7.2.5 TCPA Alarm

'MENU' + "AIS SETUP" + 'ENTER' + "TCPA ALARM" + 'ENTER'

Turns ON or OFF the alarm. The default setting is ON.

5.7.2.6 TCPA Limit

'MENU' + "AIS SETUP" + 'ENTER' + "TCPA LIMIT" + 'ENTER'

The values allowed are from 1 to 30 min. The default setting is 10 min.

5.7.3 TO SET THE CHART PLOTTER FOR RECEIVING AIS

Make sure that the AIS receiver is properly connected to the chart plotter.

The chart plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5.

Select the used serial port and transmission speed by following the procedure:

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"PORT n INPUT" + 'ENTER' + "m" + 'ENTER'

Where: n = Port 1/Port 2/Port 3

m = NMEA-0183 4800-N81-N

NMEA-0183 38400-N81-N

according to the transmission speed of your AIS receiver.

5.7.4 QUICK INFO ON AIS TARGET

By placing the cursor over a AIS target icon, the following information is

displayed:

• Vessel Name

• MMSI number

• Radio Call Sign

• SOG