Operation Manual

44 User Manual
MAX and NT/NT
+
C-CARD coexistence
• When NT
+
data and MAX data cover different areas, the chart plotter gets data
from both charts (depending on the current position).
• When NT
+
data and MAX data cover the same area, the chart plotter gets data only
from MAX chart.
3.5.1 MAP SETTINGS MENU
It is possible to select the Map Settings Menu in two modes:
'MAP' for 1 second
or
'MENU' + "MAP SETTINGS" +'ENTER"
in the following paragraphs only the first mode is indicated.
3.5.1.1 3D View (Perspective View)
'MAP' for 1 second + "3D View" + 'ENTER' + "ON" + 'ENTER'
or:
'<MODE>' more times (if set by menu, see Par. 5.3)
Note
If selected using '<MODE>', an information window describing the newly selected mode is shown on the center of
the screen for about 2 seconds, see also Par. 2.1.
Chart data may be projected in perspective mode (3D) during navigation. This
function allows setting the panoramic View of the chart.
As the upper side of the map is more compressed than the lower side, a wider map area is
visible. The perspective view allows showing more chart information immediately ahead
and around the cursor.
Fig. 3.5.1.1 - Perspective View
3.5.1.2 Palette
'MAP' for 1 second + "Palette" + 'ENTER'