Operation Manual

84
User Manual
Inhibit navigation operation
As soon as Slave mode is set, the destination cannot be placed anymore either the C-Link
Navigation Data is received from the Master or not. Also, when the C-Link Navigation
Data is received from the Master, it will not be allowed to deactivate the navigation.
Inhibit route following
While navigating to the Route received from the Master the destination is reached (either
applying distance or perpendicular criteria), the destination will not be moved to the next
Waypoint on the Route.
MOB handling
If the navigation to the external destination is active and 'MOB' is pressed on the Slave chart
plotter, the MOB is placed but the navigation to the MOB is not activated.
Notes
While navigating to the external destination the operating mode is switched to Master mode,
the navigation to the external destination will be terminated. An appropriate warning mes-
sage will be shown to notify that the navigation to the external destination is active and to
confirm whether Slave mode can be set. Setting Slave mode, the C-Link Navigation Data
will be deleted.
The C-Link Navigation Data are deleted at Power Off.
4.7.1.5 C-Link Navigation Data: acquisition and display
As soon as the C-Link Navigation Data is received, the Slave parses the information
received and executes the relative actions depending on its current working status.
Important
When the navigation to the external destination is activated, the Slave chart plotter will show all relevant C-Link
Navigation Data exactly like when the destination is not the external one: (Destination Name, DST and BRG to
Destination, calculate XTE, calculate TTG etc.). These values will be displayed all places where required and they will
be used to format NMEA-0183 output data.
4.7.1.6 Graphical representation on Map Display
Fig. 4.7.1.6 - Graphical Displaying