User's Manual

| 11English
Getting Help
Q5: How to use WPS button?
Q3: How to power off your camera?
Q4: What can I do when camera is no response?
A5: You can use WPS button to connect camera to internet.
A3: You can press Power button for 3 seconds to turn it off
(with 3 beep sound).
A4: You can press Power button for 10 sec to reset camera back
to power off state. To turn on camera again, you need to press
Power button twice.
Press the WPS button on AP.
You can go to page 5, step 7 to step 14 to start live view.
Press WPS button on camera, LED
will ash and turn to steady green
when connected.
WPS
Step 1. Step 2.
LED & Beep
Condition LED Beep
Power on Steady red for 20 seconds N/A
Power off No indication 3 times
Connect to
internet
Connecting: Flash green
Connected : Steady green
N/A
Fail connect
to internet
Flash red for 10 seconds then turn to orange N/A
Low battery No indication 3 times
Firmware
upgrade
Flash between green and orange back and
forth, and turn to steady green when completed
N/A