Power Up your Computer Remotely QDR-TELS USER GUIDE ( Version 1.0 ) QDR-TELS © 2003 Strategic Vista Corp.
1. QDR-TELS Introduction The QDR-TELS module is an accessory to the VISTAPRO 4 which allows you to power up/power down your computer remotely via the telephone. Note that you must also be using the I/O Alarm block with your VISTAPRO 4 in order to incorporate the QDR-TELS. 1.1. Items in the Package 3 3 3 3 3 The QDR-TELS module USB Cable Telephone Cable DC Power Adapter User Guide 1.2.
2. QDR-TELS Installation Step 1: Connect the QDR-TELS to the I/O Alarm Block of the VistaPro 4 Using the USB Cable supplied, plug one end into the USB port found on the I/O Alarm Block (see diagram) and the other end to the USB port found on the QDR-TELS module. Step 2: Connect the QDR-TELS to the premises telephone line. Using the supplied telephone cable, plug the RJ-11 modular plug into the ‘TEL IN’ RJ-11 jack, (located on the back of the QDR-TELS Module).
3.
NOTES: In order for the QDR-TELS to operate properly, the VistaPro 4 and I/O Alarm Board must already be installed in the PC with particular attention to the items below: 1. The VistaPro 4 main board and I/O board have to be connected each other.(I/O board cable connector) 2. The power supply port for camera power on the VistaPro main board must be connected to the PC Power Supply. (Power supply cable) 3.
4. Remotely Turning the PC ON/OFF using the QDR-TELS 1) 2) Call the premise from a remote location. After the designated number of rings, the module will pick up and request a PIN. If a valid PIN is entered, the QDR-TELS module will prompt to the user the current status of the computer, (On or Off). At this time, the user is presented with the following options. Order 1 USER 2 when Computer is OFF when Computer is ON Connecting telephone. Connecting telephone. Ringing. Ringing.