IMPORTANT INSTRUCTIONS SAFETY INSTRUCTIONS Warning – To reduce the risk of fire, electric shock, or serious personal injury: Do not use this product near water; e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, or the like. • Situate this product away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. • • Operate the product only with the supplied power adapter.
MONITOR STAND INSTALLATION Assemble the monitor stand before using the monitor. To assemble the monitor stand 1. Lay the monitor face on a clean, soft surface. 2. Align the monitor stand to the base of the monitor. 3. Tighten the screw clockwise to secure the monitor stand. NOTE: The screw is included with the package contents.
BASIC CONNECTION GENERAL PARTS AND OPERATIONS 1.AUTO button- Press this button to automatically adjust the screen display; in menu setting page, press this button to return to previous menu page. 2.UP button- In menu setting page, press this button to move UP/RIGHT. 3.DOWN button- In menu setting page, press this button to move DOWN/LEFT. 4.+ button- Press this button to enter BRIGHTNESS setting page directly. 5.- button- Press this button to enter CONTRAST setting page directly. 6.
MENU OPERATION Press the MENU button to enter the menu setting page as shown below: • Use the UP or DOWN button on the unit to select submenus and press the [MENU] button to enter the submenu. (In this submenu page, you can press the UP or DOWN button to select different submenu page as desired.) • Press the [MENU] button again to enter next menu setting page you select. Press the UP or DOWN button to select different items as desired.
3. TRACKING 3.1 HORIZONTAL - This item is used to move the screen display to the left or right. - The HORIZONTAL can be adjusted from 0-100. 3.2 VERTICAL - This item is used to move the screen display up or down. - The VERTICAL can be adjusted from 0-100. 3.3 CLOCK/PHASE/SHARPNESS - Press UP or DOWN button to select CLOCK, PHASE or SHARPNESS and press [MENU] button to confirm, then press + or - button to adjust. - The CLOCK/PHASE can be adjusted from 0-100. - The SHARPNESS can be adjusted from 0-10. 4.
MAINTENANCE ● Be sure to press POWER to set the monitor to standby mode and disconnect the AC adaptor before maintaining the monitor. • Wipe the monitor with a dry, soft cloth. • If the surfaces are extremely dirty ,wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth. • Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust. SPECIFICATIONS 1.