Quick Start Guide

Troubleshooting
1. After installing the extender/repeater, I still have low signal strength on my camera(s).
Make sure that your faraway camera(s) are connected to the extender/repeater directly. To check
this, go to the Lorex Home Center’s Device Manager settings from the homescreen and see if your
camera(s) are still connected. If you’re nding that your camera(s) are still connected to the Lorex
Home Center and not to the extender/repeater, then you will need to do the following:
Your camera(s) should now automatically connect to the extender/repeater as long as the signal
from the extender/repeater is stronger than the signal from the Lorex Home Center. If you are still
having trouble, consider moving the extender/repeater closer to the camera(s).
2. The extender/repeater is showing low signal strength. How do I x this?
Go to the page “Placement of the Lorex Home Center Extender” on this quick start guide for
optimal placement recommendations.
3. How do I reset the extender/repeater?
Press and hold down the reset button on the back of the extender/repeater for about 10 seconds
until you hear the chime. The extender/repeater will then reset and the LED light status will ash
blue to indicate that it’s ready to pair to your Lorex Home Center.
1. Power off the camera(s) with low Wi-Fi signal strength.
2. Make sure the extender/repeater is powered on and connected to the Lorex Home Center.
3. Power the camera(s) back on.