L15LD400 Series Quick Set-Up Guide R1
4
1. Access the Main Menu Setup screens, and navigate to the SYSTEM
MENU - EXTERNAL DEVICE - TCP/IP SETUP - IP SETUP option.
2. Record the MAC Address of your system. This information is NECESSARY
for the DDNS Setup process.
3. Confirm that the DHCP MODE is set to AUTOMATIC. This will allow your
system to lease an IP ADDRESS from your router. If the system not set to
AUTOMATIC, change the setting and click IP DETECT - the system will
obtain an IP address.
4. The IP PORT is 50000 by default. The IP Address, Gateway and Subnet are
assigned to your system by your router. If the settings are not displayed,
and the unit is set to DHCP MODE: AUTOMATIC, you may need to click IP
DETECT - the system will obtain an IP address.
STEP 2 - SET UP LOCAL VIEWING ON YOUR PC
RETRIEVE SYSTEM INFORMATION:
RECORD THE IP AND MAC ADDRESSES IN THE SECTION BELOW:
Insert the Lorex Client 2.0 Software CD into your local computer’s
CD ROM drive and proceed with the installation.
INSTALL SOFTWARE:
(on your local computer)
1
2
Follow the installation screens to complete Lorex Client 2.0
Software installation.
LOREX CLIENT 2.0 SOFTWARE:
(on your local computer)
3
Close the CD Menu Screen. A Lorex Client Icon will appear on your
desktop.
LOREX CLIENT 2.0 SOFTWARE:
(on your local computer)
4
*YOUR OBSERVATION SYSTEM MUST
BE CONNECTED TO A ROUTER PRIOR TO
POWERING IT ON.
IP ADDRESS: . . .
MAC ADDRESS:
(Required for DDNS registration)
For Lorex Client Software
requirements, please refer to
Page 9 of this guide.
1
2 3 4 5
Double-click the Lorex Client 2.0 Software icon on your desktop to run the
program.
RUN THE LOREX CLIENT 2.0 SOFTWARE:
(on your local computer)
NOTE: The system will lease networking
information from your Router. If you wish
to set your information manually, then
set the DHCP MODE to MANUAL. Please
consult your Hardware Manual for further
Menu options.