Use and Care Manual

A
B
C
1080P WIRELESS DIGITAL SECURITY CAMERA SYSTEM
LWU3720 SERIES
Quick Start Guide
A. Installing the Cameras
Mount the camera to the wall or ceiling using the included screws and
drywall anchors (optional).
1
2
Connect the camera power adapter to the camera. Connect
power adapter to a power outlet.
Before you permanently install your cameras:
www.lorextechnology.com
LWU3720_SERIES_QSG_EN_R1
Getting Started
3
Adjust the angle of the camera until the desired view is set. Tighten
the lower / upper screws and the adjustment ring to secure the camera
position.
The LWU3724 system comes with the following
components:
4x wireless 1080p indoor/outdoor cameras*
4x antennas for cameras (pre-attached)*
4x power adapters for cameras*
4x mounting kits for cameras*
1x wireless indoor/outdoor receiver
2x antennas for receiver (pre-attached)
1x mounting kit for receiver
1x double-sided tape for receiver
*Quantity only applies to the LWU3724.
Installation Tips
Plan where and how they will be positioned.
Determine where you will route the cable that
connects the camera to the power adapter.
Verify the camera’s performance by observing
the image on a monitor when the camera
is positioned where it will be permanently
installed.
Avoid installing cameras in locations that
require the wireless signal to pass through
cement, concrete and metal structures. This
will reduce the transmission range.
For outdoor use, installation in a
sheltered location is recommended.
NOTE:
If you run the cables along the
wall / ceiling, you must run the ca-
ble through the cable notch on the
base. This will keep the camera
base flush to the wall /
ceiling when mounted.
Cable Notch
B) Loosen lower screw
with the included Allen
key to adjust the
camera’s vertical position.
C) Loosen upper screw
with the included Allen
key to rotate the camera
housing.
A) Turn the adjustment
ring to tighten / loosen
the stand connection.
Adjust the camera’s
horizontal position.
B. Installing the Receiver
Plug the USB cable from the wireless receiver into your DVR.
1
Use the included double-sided tape to securely attach the receiver to
a flat surface.
Use the included screws to mount the receiver to a wall.
OPTIONAL
OR
2
NOTE: For optimal video frame rate performance, we recommend you
do not install more than 4 digital wireless security cameras in the
same environment.
NOTE: The LWU3724 is compatible with Lorex
LH060 series DVRs only.
Visit www.lorextechnology.com for the most
up-to-date list of compatible recorders.
ATTENTION: Make sure to first connect and power on the
cameras before powering on the receiver. This will ensure a
proper connection.
Need Help?
Visit us online for up-to-date software and
complete instruction manuals
1
3
Go to www.lorextechnology.com
Search the model number of your product
Click on your product in the search results
Click the Downloads tab
2
4
NOTE: Number of cameras and accessories may vary by model. Check your package label
for specific content information.