Use and Care Manual

143
Configuring Camera Settings using a Web Browser
English
• PIR: Use the PIR motion detector to trigger email alarms. The PIR motion detector
uses changes in temperatures (e.g. from a person moving around in front of the
camera) to determine if there is motion. PIR motion detection is less effective at
higher temperatures.
NOTE: You may also select both PIR and Motion to receive alarms from both motion
triggers.
• Schedul
e: Send email alarms based on the settings configured under Scheduling
page. See “Scheduling (Configuring Recording and Alarm Schedules)” on page 148.
• Disable: Disable email alarms.
2. If you have selected Motion, under Motion Sensitivity, sel
ect the motion detection
sensitivity between 1 (High) and 10 (Low). If Motion Detection Sensitivity is set to 1,
motion detection will be triggered if a moving object is larger than 1% of the video
area. If it is set to 10, a moving object must be larger than 10% of the video area to
trigger motion detection.
NOTE: This setting does not affect the PIR motion detector.
3. Under T
rigger Interval, enter the minimum time (in seconds) the camera will wait in
between email alarms. If this Interval is set too low, you may receive a lot of
messages.
4. Under Email Recipient, ent
er up to 3 email addresses that will receive email alarms.
5. Click Sa
ve & Apply to Save email alarm settings.
NOTE: If you want to use a custom SMTP server to send Email messages, click Advanced,
enter your SMTP server information, and click Save & Apply.
8.4.2 SPEAKER ALARM (CONFIGURING AUDIO ALARMS)
Configure audio alarms using a speaker (not included) connected to the camera. Audio
alarms can be set up to go off when the camera detects motion. This is helpful if you want