Use and Care Manual

22
Getting Started
10.Tap the camera in the Camera List to connect. If you cannot connect, check to make
sure you have entered the correct wireless password and that the camera is in signal
range of your wireless router.
2.3.3 IPAD WIFI SETUP
NOTE: The camera must be connected to your router using an Ethernet cable before you
can set it up to use WiFi.
1. Connect to your camera using Lorex Ping iPad. For details, see “Connecting to your
Camera on iPad” on page 12. Y
our iPad must be connected to your WiFi, not your
3G/mobile network.
2. Press to open the edit camera screen.
3. Tap Camer
a Settings. Enter the camera’s admin username and password. By
default, the admin username is admin and the password is left blank. Tap OK.
4. Tap Netw
ork then WiFi Network.
5. Slide Wi
-Fi to ON. The camera will scan for available networks.
Camera Settings
WiFi Network
Network