Installation Guide

WIRELESS DIGITAL SECURITY CAMERA
LW2231
QUICK START GUIDE
A. Installing the Camera
B. Connecting to a DVR
Connect the BNC cable to your
DVR’s video input.
1
Mount the camera to the wall or ceiling using the
included screws. Use the included anchors as needed.
1
2
Connect the camera power adapter
to the camera. Connect power
adapter to a 120V AC power outlet.
Before you permanently install your camera(s):
ATTENTION: Make sure to first
connect and power on the camera
before powering on the receiver.
www.lorextechnology.com
LW2231_QSG_EN_R1 Page 1
Getting Started
3
Loosen the two
thumbscrews (1,2)
and the adjustment
ring (3). Adjust the
angle of the camera
until the desired
view is set. Tighten
the thumbscrews
and the adjustment
ring to secure the
camera position.
2
3
Connect the receiver
power adapter to
the receiver. Connect
the power adapter to
a 120V power outlet.
This system comes with the
following components:
1x wireless camera
1x wireless receiver
1x antenna for camera (pre-attached)
1x antenna for receiver (pre-attached)
2x power adapters (for camera and receiver)
1x BNC-to-RCA adapter
1x camera mounting kit
2x double-sided tape for receiver
1x Instruction Manual
1
2
3
Installation Tips
It’s all on the Web
For detailed setup information, please refer
to your Instruction Manual. For additional
information and accessory purchases,
please visit our website.
REGISTER NOW TO RECEIVE
3-MONTHS EXTENDED WARRANTY
www.lorextechnology.com/warranty
Need to extend the wireless range?
See instruction manual for further details.
www.lorextechnology.com/support
Plan where and how they will be
positioned.
Determine where you will route the
cable that connects the camera to the
power adapter.
Verify the camera’s performance by
observing the image on a monitor when
the camera is positioned where it will be
permanently installed.
Avoid installing the camera in a location where
the wireless signal must pass through cement,
concrete, or metal structures. This will reduce
the transmission range.
Power cables are only weatherproof when fully inserted
at the connection point. Power cables should not be
submerged in water.
For outdoor use, installation in a
sheltered location is recommended.
NOTE: It is not recommended to install more
than 4 digital wireless security cameras in the
same environment to maintain optimal video
frame rate performance.
Installing Multiple Wireless
Cameras
When installing multiple digital wireless
security cameras in the same environment,
maintain at least 4” / 10cm between the
receivers to optimize camera performance.
NOTE:
If you run the cables
along the wall / ceiling,
you must run the cable
through the cable notch
on the base. This will
keep the camera base
flush to the wall /
ceiling when mounted.
Cable Notch
CONNECTING to TV:
Connect the other end of the adapter to
the video input on your TV. Connect the
RCA cable from the receiver to the audio
input on your TV. Select the input for your
camera on the TV.
Connect the included BNC-to-RCA adapter
to the BNC connector on the receiver.
4
Remove protective film from the
camera lens.
Connect the RCA cable to the
corresponding DVR audio input
(e.g. Video Input 1 / Audio Input 1)
BNC video*RCA audio
RCA audio
BNC video
4
Use the double-sided
tape to securely attach
the receiver to a flat
surface.
OPTIONAL:
* BNC-to-RCA adapter attached.