User's Manual

QLR1660 User Manual
34
▶ For each camera
▪ Region Viewer: On this viewer, you can set the region and test. The active region is shown with a red grid.
▪ Sensitivity: Setup the sensitivity of brightness in the motion-detection region.
▪ Min. detect area: Setup the rate (sensitivity) of motion detection in the motion-detection region by minimum size of
motion-detection area. The larger the number is, the lower the sensitivity. Conversely, the smaller
the size(number) is, the higher the sensitivity..
▪ Motion recording duration: Setup the recording duration when motion occurs. (1~60 sec)
▪ Region select: - Select all: The region is all selected.
- Draw: Click ‘Draw’ and draw the grid by mouse-dragging on the viewer as desired.
- Clear all: All regions are cleared.
- Erase: Clear specific regions of the grid by mouse-dragging on the viewer as desired.
▪ Test start: Start the test of the motion-detection on the viewer.
▪ Test stop: Stop the test.
The Motion Detect symbol (
) is displayed on screen when motion occurs in the selected regions.
▶ Camera association: Select cameras to be associated and recorded together when motion occurs at this camera.
[NOTE] This association will not affect cameras configured to record upon Sensor input. Namely it will be not
recorded at the camera set with Sensor recording when motion occurs even if the camera is associated.
▶ Output association: Select the output condition(s) that will occur when motion occurs at this camera.
▪ Speaker out: If selected, speaker will be operated according to ‘Speaker, Relay out’ setup when motion occurs at
this camera.
▪ Mail out: If selected, the capture-mail will be sent according to ‘Mail’ setup when motion occurs at this camera.
▪ Relay out: If selected, the relay will be operated according to ‘Speaker, Relay out’ setup when motion occurs at this
camera.