User's Manual

QLR1660 User Manual
8
1.1.5 Watch-dog Installation for QLR1660
If the system is stopped by abnormal operation, watchdog will automatically reboot the computer. The watchdog
will restart the computer automatically if it did not receive any response from the system for more than 5 minutes.
Each QLR1660 video capture card has a Reset pin (4pin) for watch-dog. It should be connected to the
motherboard’s reset jumper and computer’s reset switch. Your motherboards’ RESET pin position might be
different from the illustration below. Please refer to your motherboard user manual for the actual
[NOTE] In case QLR1660-2 with two video capture cards, the cable should be connected to the
reset pin (4pin) for watch-dog of master card among two cards. Master card is that card is inserted in
slot located near to VGA card slot.
Reset pin for Watch-dog
(4pin)
QLR1660 video capture card