Quick Start Manual

ManualsBrandsLorex ManualsCamerasLorex Wireless security cameras

WIRELESS DIGITAL SECURITY CAMERA

LW2110 SERIES

QUICK START GUIDE

NOTE: Avoid installing in a location which

requires the wireless signal to pass through

cement, concrete and metal structures. This will

reduce the transmission range.

Getting Started

A. Camera Setup

B. Receiver Setup

Surveillance Recorder (DVR)

with BNC inputs:

Attach the BNC connector of the

receiver directly to a video input of the

DVR.

TV with RCA Inputs:

1. Attach the included BNC/RCA

adapter to the BNC cconnector on

the receiver.

2. Attach the receiver to a composite

video input of the TV.

Connection Options:

Connect power adaptor to local

120V AC power outlet

Mount camera stand to the wall.

Connect one end of the camera

Power Adapter to the camera

and the other end to an

electrical outlet.

NOTE: If the receiver is not able to directly attach to your TV or DVR because of space constraints

or blockage of wireless signal, use the included BNC extension cable to reposition the receiver.

This Wireless Digital Security

Camera System comes with the

following components:

• Digital Wireless Color Camera*

• Camera Stand*

• Wireless Receiver*

• Power Adaptors for camera*

and receiver*

• BNC/RCA Adapter*

• 3ft BNC extension cable

• Mounting Hardware*

• Instruction Manual

• 2-way Power Splitter

(LW2110PK2 only)

* Number of items may

vary by model. Check your

package for specific content

information.

Secure Camera to the mounting

stand. Adjust the angle of the

camera until the desired view is

set (1). Tighten the thumbscrews

to secure the desired camera

position (2).

NOTE: Wireless cameras require a power

source to operate.

NOTE: Before you install a camera, carefully plan where and how it

will be positioned, and where you will route the cable that connects the

camera to the power adaptor. Before starting permanent installation,

verify its performance by observing the image on a monitor when the

camera is positioned where it will be permanently installed.

Powering Multiple Receivers (LW2110PK2 only)

Connect power adaptor

to local 120V AC power

outlet.

Connect the

power adapter

to the power

splitter cable as

shown.

Connect the ends

of the power

splitter Cable to

the receiver.

Connect one end of the Power Adaptor to the

receiver and the other end to an electrical outlet.

ATTENTION: Make sure to first connect and power on the camera before

powering on the receiver; this will ensure a proper connection.

a. b. c.

C. Powering a Single Receiver

www.lorextechnology.com

LW2110 Series QSG_EN_R2 Page 1

Summary of content (2 pages)

PAGE 1
W I RELESS DIGITAL SECU R I T Y C A M E R A LW2110 Series Quick Start Guide Getting Started A. Camera Setup Mount camera stand to the wall. 1 2 * Secure Camera to the mounting stand. Adjust the angle of the camera until the desired view is set (1). Tighten the thumbscrews to secure the desired camera position (2). NOTE: Before you install a camera, carefully plan where and how it will be positioned, and where you will route the cable that connects the camera to the power adaptor.
PAGE 2
W I RELESS DIGITAL SECU R I T Y C A M E R A LW2110 Series Quick Start Guide E. Multi Digital Wireless Camera Installation D. Receiver Overview 1. Wireless Antenna 2. Resolution* button: Press to switch between VGA and QVGA video resolutions. 3. Front LED: Lights up in green to indicate power to the receiver. 4. Pair: See product manual for details on this function. 5. BNC Connector: Connect the BNC Connector to a DVR or BNC Extension Cable.