Operation Manual

• The stopwatch can measure up to 30 minutes
in 1/5 second increments.
•After 30 minutes, it will start counting again
fron “0” repeatedly up to 6 hours.
■ HOW TO USE THE STOPWATCH
A
Stopwatch 1/5-second hand
■ ADJUSTING THE STOPWATCH HAND
POSITION
•If the stopwatch hands will not return to
the “0” position when the stopwatch is reset
or when the battery is replaced with a new
one, follow the procedure below to reset
the hands.
Stopwatch
minute hand
Stopwatch
1/5-second
hand
1. Pull out Crown 1 to the second click.
2. Press button “A” repeatedly to reset the
stopwatch minute hand to the “0” position.
Press button “B” repeatedly to reset the
stopwatch 1/5-second hand to the “0”
position.
* The hands move quickly if the respective
buttons are kept pressed.
3. Push Crown 1 back in to the normal position.
* After adjusting the hand position, set
the time.
■ RESETTING THE BUIT-IN IC
• In case any of the hands should move improperly,
follow the procedure below to adjust the
hand movement.
B
Stopwatch minute hand
Second click
BA
A
B
Crown 1
Second click
1. Pull out Crown 1 to the second click.
2. Press buttons “A” and “B” simultaneously
3. Push Crown 1 back in to the normal position.
* Before using the watch again, be sure to
adjust the position of the stopwatch hands
and set the time and alarm.
■ LUMIBRITE WATCH
(dial, hands, buttons, case, bezel,
strap, etc.)
✩ If your watch is a LORUS LUMIBRITE watch,
it has following features.
LORUS LUMIBRITE watches absorb and store
light energy from natural and artificial light
sources and emit light in the dark. They are
made of environmentally friendly material,
and therefore, are harmless to human beings
and the environment.
• With a full charge, LORUS LUMIBRITE
watches glow in the dark hours longer than
conventional luminous watches of this type.
If exposed to a light of more than 500 lux
(i.e., the brightness of a typical office) for
approximately 10 minutes, or direct sunlight
for 2 minutes, they will glow for hours.
• Since LORUS LUMIBRITE watches emit
the light they store, the brightness will
decrease gradually over time. The length
of time they will glow may also differ slightly
depending on such factors as the brightness
of and distance from the light source used
to charge the watch.
✩ Before using the stopwatch, be sure to check
that Crowns 1 and 2 are set at the normal
position, and press button “B” to reset the
stopwatch hands to “0” position.
Standard measurement
Stopwatch operation
A
Start Stop Reset
A
Accumulated elapsed time measurement
B
A
Start Stop Restart Stop Reset
A A
B
A
* Restart and stop of stopwatch
can be repeated by pressing
button “A”.
A
Start Split Split Stop Reset
release
A
Split time measurement
BB
B
* Measurement and release of
split time can be repeated by
pressing button “B”.
Measurement of two competitors
A
Start Finish 2nd Finish Reset
time
competitor time
of 1st finishes of 2nd
competitor competiror
BB A B
Notes on crown operation while the
stopwatch is in use:
1. If Crown 1 is pulled out to the second
click, the stopwatch hands are reset to
“0” position.
2. If Crown 2 is pulled out to the first or
second click, the stopwatch hands are
reset to “0” position.
3. When the stopwatch has been reset and
button “A” is pressed before the hands
reach “0” position, the stopwatch still
starts counting when button “A” is pressed.
Crown 1