TM LOSB0102 1/10th Desert Truck RTR TM Not responsible for errors. All prices subject to change without notice. Losi, a Division of Horizon Hobby, Inc.
TM Table of Contents Introduction Introduction..................................................................................................2 Safety Precautions:......................................................................................3 Supplied and Required Equipment......................................................4 Battery/Charging.........................................................................................5 Technical Overview............................................
TM Safety Precautions Batteries and Charging: The Desert Truck uses rechargeable batteries such as NiMH. These batteries all have special requirements to preserve performance and last a long time. Read all instructions and precautions that are provided with the batteries intended to be used in the Desert Truck. • Read all instructions provided by the manufacturer of the batteries. • Responsible adult supervision is necessary while charging batteries.
TM NiMH battery charger with automatic “peak detection” Supplied and Required Equipment recommended. Supplied tools: 2-Way wrench Transmitter / Receiver BIND Plug DYN4044 Vision Peak 2 AC/DC Charger Using your charger: Four (4) Hex Wrench “L” shaped .050, 1/16, 5/64, and 3/32 If you do not yet have a charger a peak-detecting charger will provide the performance required and take care of your expensive batteries.
TM If you are going to be using a charger other than a peak detection charger it is important to have your battery fully discharged prior to recharging. Many of these have a 15-20 minute timer that allows you to set to the amount of charge time. If the battery was not fully discharged from prior use, you can potentially over charge your battery pack. Do not charge any battery unattended, and monitor for heat build up. If the battery pack is more than warm to the touch immediately discontinue charging.
TM The Losi Desert Truck Overview
TM The Losi LSR-3000 Radio System Overview Antenna Dual Rate Adjustment (ST. D/R) Steering Wheel Steering Trim (ST. Trim) Throttle Trim (TH.
TM Desert Truck Electronics System Overview Motor Male Battery Plug MRX3000 Receiver On/ Off Switch Setup Button Bind Plug MSC 12RB 12T ESC Digital Servo
TM MSC 12RB 12T Fwd/Rev ESC Adjusting theTransmitter Features • High power FET control with proportional forward and reverse. • High frequency design delivers smooth speed transition. • Thermal Overload Protection prevents damage due to overcurrent conditions. • Pre-wired with Tamiya battery plug and bullet-style motor connectors. • Designed to operate with stock motors (12 turns or higher). • Push-button programming makes setup a breeze. Operation.......................................
TM Installing Batteries: Transmitter Remove the battery cover from the bottom of the transmitter by sliding it away from the base of the handle. Install the four (4) AA size batteries (not included) into the base, noting polarity when inserting each battery. Transmitter with batteries Reinstall the battery cover by sliding it back on the handle base.
TM Battery Pack(s) To install the battery pack remove the battery hold-down strap by removing the clip from the front mounting boss, and then, while lifting the strap, pulling forward in one motion. After you have inserted the fully-charged battery pack reinstall the battery hold-down strap. Notice that the battery hold-down has a flat side while the other side has strengthening ribs; the rib side should be facing down to the battery.
TM Quick Start Note: Please read the entire manual to gain a full understanding of the Desert Truck vehicle, fine-tuning the setup and performing maintenance. 1. Read the safety precautions found on page 3. This is important for your safety and prevention of personal injury. 2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the Manufacturer’s Supplied instructions for battery charging information. 3. Install the AA batteries into the LSR-3000 Transmitter (see page 10).
TM Losi LSR-3000 Radio System The Losi LSR-3000 Radio System with Spektrum™ 2.4GHz DSM® Technology radio system included with the Desert Truck operates on 2.4GHz and provides 79 unique channels, which are automatically selected when the transmitter and vehicle are turned on. The communication between the transmitter and receiver begins in the few seconds after both are turned on. They are bound together from the factory to uniquely operate together.
Steering and Throttle End-Point Adjustment Pots (4) Receiver There is no adjustment required of the receiver. Please note the different slots for connection. Auxiliary Channel Throttle Channel Steering Channel Binding Port There is Bind, channel one, channel two and auxiliary slots. The bind slot is used to bind the transmitter to the receiver. The Losi LSR-3000 DSM® radio system uses a unique GUID ID to “bind” the transmitter to each receiver.
TM Driving the Desert Truck Please note the following precautions before running your Desert Truck. • The Electronics in this vehicle are not waterproof and you must avoid running the vehicle in or through standing water, wet grass, mud or snow. • This vehicle is quick: o Do not run the vehicle if it will be out of sight for any amount of time. o Do not drive your vehicle near a crowd of people. • Perform a check of the vehicle before going out to run it. o Ensure the tires are not coming off the rims.
TM Tuning, Adjusting & Maintaining the Desert Truck Tuning the Front End of the Desert Truck Shock Location: The Desert Truck has two mounting locations on the front shock tower. The position can be easily adjusted by simply moving the top of the shock to another hole. The standard location (outside hole on the tower) works best on most surfaces. Moving the top of the shock inward a hole will slow steering response and make the Desert Truck smoother in bumps.
TM Inboard Camber Location: The Desert Truck has three different inner locations with vertical adjustment for the front camber tie rod. In general, the lower or further out the inside position is, relative to the outside, the more camber gain (total camber change through the total throw of the suspension) is present. This is an adjustment that is difficult to make a generic statement for as it can have slightly different results on various conditions.
TM but provide more on-power steering on high traction surfaces. Pro-squat will also help the Desert Truck from pulling wheelies on high bite surfaces. Also available is an aftermarket part that is a 0 degree rear pivot block (LOSA2112), if pro-squat is desired it is best to start with this option. Tuning the Rear End of the Desert Truck Shock Location: Moving the shocks out on the arm will result in less forward traction and let the Desert Truck make more of an arc through the exit of the turn.
TM Adjusting Gear Mesh Battery Position: This is a critical adjustment that is often overlooked but can be very useful. Start by running the battery spaced in the middle (standard setup with 6-cell battery pack). Moving the battery back can improve rear traction on slippery surfaces and steering response. Moving the battery back too far can cause the rear end to swing through turns on some tracks and “dump” the rear end causing instability issues. This is a result of having the weight too far back.
TM Vehicle runs slowly/slow acceleration: Troubleshooting your Desert Truck Check the battery connectors. Confirm that battery is charged. Many questions are the result of simple user errors or minor adjustments which are easily addressed. If after reading below you cannot resolve your problem, then please call Horizon Customer Service at 1-877-504-0233. Vehicle will not reverse: Make sure the throttle trim is at neutral. Radio system does not work properly: Recalibrate/Setup the ESC (see page 9).
TM Warranty Information If you as the Purchaser or user are not prepared to accept the liability associated with the use of this Product, you are advised to return this Product immediately in new and unused condition to the place of purchase. Warranty Period Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase by the Purchaser.
TM Non-Warranty Repairs RC Terminology Should your repair not be covered by warranty the repair will be completed and payment will be required without notification or estimate of the expense unless the expense exceeds 50% of the retail purchase cost. By submitting the item for repair you are agreeing to payment of the repair without notification. Repair estimates are available upon request. You must include this request with your repair.
TM Profiles – The MSC 12RB has two (2) preset profiles. Forward Only and Forward and Reverse profile. The Forward only profile can be selected for racing purposes. The Forward/Reverse profile is great for running in your neighborhood. Receiver – A device mounted into the vehicle that receives and decodes a signal sent by a transmitter. Servos, ESC and other devices are plugged into the receiver. Resistance – As used here refers to the power loss from the battery to the ESC and Motor.
TM Replacement Parts List Part Number Description LOSA1022 LOSA1113 LOSA1118 LOSA1146 LOSA1150 LOSA1610 LOSA1615 LOSA1620 LOSA2006 LOSA2007 LOSA2105 LOSA2108 LOSA2143 LOSA2164 LOSA2166 LOSA2919 LOSA2930 LOSA2931 LOSA2934 LOSA2942 LOSA2960 LOSA3042 LOSA3060 LOSA3066 LOSA3075 LOSA3079 LOSA3123 LOSA3124 LOSA3132 LOSA3928 LOSA4004 LOSA4015 LOSA4060 LOSA4061 LOS4116 LOSA4109 LOSA4112 LOSA4122 LOSA4125 LOSA4126 LOSA4132 LOSA4136 LOSA4170 LOSA4136 LOSA4170 LOSA4224 LOSA5015 LOSA5023 LOSA5026 LOSA5045 Price Fron
TM Part Number Description Price LOSA5047 LOSA5156 LOSA5224 LOSA6001 LOSA6020 LOSA6030 LOSA6044 LOSA6074 LOSA6100 LOSA6102 LOSA6201 LOSA6204 LOSA6206 LOSA6210 LOSA6215 LOSA6216 LOSA6229 LOSA6230 LOSA6233 LOSA6300 LOSA6303 LOSA6305 LOSA6306 LOSA6350 LOSA6401 LOSA6903 LOSA6908 LOSA6909 LOSA7007 LOSA7107 LOSA7679B LOSA9941 LOSA17679B LOSA27679B LOSB8057 LOSB8058 LOSB8059 LOSB8060 LOSB8061 LOSB9998 LOSB9999 Shock Pistons #55 (Orange) (4) .....................................................................
TM Optional Parts for the Desert Truck Part Number Description LOSA2961 LOSA3065 LOSA3927 LOSA3929 LOSA3930 LOSA3932 LOSA3933 LOSA4060C LOSA4061C LOS4112 LOS4113 LOS4114 LOS4115 LOS4117 LOS4118 LOS4119 LOS4120 LOS4121 LOSA5062 LOSA6912 LOSA7058 LOSA7158 LOSA7684B LOSA7684V LOSA9713 LOSA9831 LOSA9940 LOSB9861 LOSB9900 Price CVD Rebuild Kit: Desert Truck....................................................................................................................$5.
TM 27
TM 28
TM 29
TM Use this page to record tuning information 30
TM Use this page to record tuning information 31
TM TM ©2008 Losi, A division of Horizon Hobby, Inc. Not responsible for typographical errors. All pricing subject to change without notice.