/10-SCALE ELECTRIC SHORT COURSE TRUCK LOSB0105 1/10 STRIKE Short Course Truck RTR LOSB0105BD 1/10 STRIKE Short Course Truck Bind-N-Drive CONNECT - REGISTER - WIN Register your product online so we can notify you about the latest option parts, product updates, tech tips, service bulletins and more. Visit WWW.LOSI.COM/REGISTER to stay connected. For registering your Losi Product you will be automatically entered for a chance to win the Losi-Pick-Your Prize Sweepstakes.
Table of Contents Introduction Introduction................................................................................ 2 Thank you for purchasing the Losi® 1/10 Strike Short Course Truck. We are confident you will be satisfied with the performance of this durable and resilient vehicle. Safety Precautions.................................................................... 3 Battery/Charging.......................................................................
Safety Precautions Batteries and Charging: We hope you operate this RC model in a safe, reasonable and cautious fashion in order to enjoy your vehicle. Should you operate this vehicle without a cautious and reasonable approach it may result in serious injury and/or property damage. Only you can control and make certain that safety precautions and instructions are followed. The 1/10 Strike SCT uses rechargeable batteries such as NiMH or LiPo.
Supplied and Required Equipment Supplied Tools: 2 Four (4) AA batteries 3 NiMH battery charger with automatic “peak detection” or LiPo-compatible charger recommended.
The Losi 1/10 Strike SCT Overview Rear Suspension Arm Rear Tie Rod Rear Body Mount Slipper Clutch Adjustment Access Motor On/Off Switch EC3 Battery Connector Battery Positioning Blocks Digital Servo 2.
The Losi LSR-3000 Radio System Overview Steering Wheel Steering Trim (TH. Trim) Antenna Power On/Off Switch Throttle Trim (TH.
1/10 Strike SCT Electronics System Overview Motor MRX-3000 DSM Receiver MSC 12L 12T ESC Male EC3 Battery Connector One-Touch Setup Button Bind Plug 7 Digital Servo
MSC-12L Fwd/Rev ESC Features • • • • • • • • • Speed Control Programming LiPo, NiMH/NiCd compatible 4 user selectable modes—Forward/reverse, Forward only race, Practice mode with slow acceleration, and Crawler. High-power FET control with proportional forward and reverse. High frequency design delivers smooth speed transition. Thermal Overload Protection prevents damage due to over current conditions. Pre-wired with EC3 battery plug and bullet-style motor connectors.
Installing Batteries: Transmitter Remove the battery cover from the bottom of the transmitter by sliding it away from the base of the handle. Install the four (4) AA-size batteries into the base, noting polarity when inserting each battery. Transmitter with batteries installed Reinstall the battery cover by sliding it back on the handle base.
Battery Pack(s): To install the battery pack remove the battery hold-down strap by removing the clip from the front mounting boss, and then, while lifting the strap, pulling forward in one motion. After you have inserted the fully-charged battery pack reinstall the battery hold-down strap. Notice that the battery hold-down has a flat side while the other side has strengthening ribs; the rib side should be facing down to the battery.
Quick Start Note: Please read the entire manual to gain a full understanding of the 1/10 Strike SCT vehicle, fine-tuning the setup and performing maintenance. 1. Read the safety precautions found on page 3. This is important for your safety and prevention of personal injury. 2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the manufacturer’s supplied instructions for battery charging information. 3. Install the AA batteries into the Losi LSR-3000 transmitter (see page 9).
The Losi LSR-3000 Radio System The Losi LSR-3000 radio system with Spektrum™ 2.4GHz DSM® technology included with the 1/10 Strike SCT operates on 2.4GHz and provides 79 unique channels, which are automatically selected when the transmitter and vehicle are turned on. The communication between the transmitter and receiver begins in the few seconds after both are turned on. They are bound from the factory to uniquely operate together.
Receiver There is no adjustment required of the receiver. Please note the different slots for connection. Auxiliary Channel Throttle Channel Steering Channel Binding Port There are bind, channel one, channel two and auxiliary slots. The bind slot is used to bind the transmitter to the receiver. The Losi LSR-3000 DSM® radio system uses a unique GUID ID to “bind” the transmitter to each receiver.
Driving the Strike SCT How you drive your 1/10 Strike SCT will also affect your run times. If you are performing runs, going from a standstill to full speed repeatedly, you are asking a lot from your batteries and electronics. Hard acceleration draws a lot of current from any battery and will lead to shortened run time.
Tuning the Front End of the 1/10 Strike SCT Tuning, Adjusting & Maintaining the 1/10 Strike SCT Shock Location: The 1/10 Strike SCT has two mounting locations on the front shock tower. The position can be easily adjusted by simply moving the top of the shock to another hole. The standard location (inside hole on the tower) works best on most surfaces. Moving the top of the shock outward a hole will slow steering response and make the 1/10 Strike SCT smoother in bumps.
Tuning the Front End of the 1/10 Strike SCT (CONT’D) Tuning the Front End of the 1/10 Strike SCT (CONT’D) Outboard Camber Location: The 1/10 Strike SCT provides two outboard mounting options. The outer location helps the 1/10 Strike SCT stay tighter in turns with a more precise steering feel. Moving the link to the inner hole will make the steering react slightly slower and steer smoother.
Tuning the Rear End of the 1/10 Strike SCT (CONT’D) Tuning the Rear End of the 1/10 Strike SCT Shock Location: Moving the shocks in on the arm will result in more forward traction and let the 1/10 Strike SCT drive more square off the turn. Pro-squat is generated by raising the rear of the pivot relative to the front. This will decrease forward traction and initial steering, but provide more on-power steering on high-traction surfaces.
Tuning the Chassis of the 1/10 Strike SCT (CONT’D) Adjusting Gear Mesh: Incorrect gear mesh is the most common cause of stripped spur gears. To set the gear mesh, one method is to cut a narrow strip of notebook paper and thread it in between the gears. Loosen the motor screws and slide the motor and pinion gear into the spur gear. Retighten the motor screws and then remove the strip of paper.
Vehicle runs slowly/slow acceleration: Troubleshooting Your 1/10 Strike SCT Check the battery connectors. Many questions are the result of simple user errors or minor adjustments which are easily addressed. If after reading below you cannot resolve your problem, then please call the Horizon Support Team at 1-877-504-0233. Confirm that the battery is charged. Vehicle will not reverse: Make sure the throttle trim is at neutral.
Warranty and Repair Policy Warranty and Repair Policy (CONT’D) Age Recommendation 14 years or over. This is not a toy. This product is not intended for use by children without direct adult supervision. If you as the Purchaser or user are not prepared to accept the liability associated with the use of this Product, you are advised to return this Product immediately in new and unused condition to the place of purchase. Warranty Period Exclusive Warranty- Horizon Hobby, Inc.
Warranty and Repair Policy (CONT’D) Warranty and Repair Policy (CONT’D) Warranty Inspection and Repairs Germany Electronics and engines requiring inspection or repair should be shipped to the following address: To receive warranty service, you must include your original sales receipt verifying the proof-of-purchase date. Provided warrantyconditions have been met, your Product will be repaired or replaced free of charge. Repair or replacement decisions are at the sole discretion of Horizon.
Declaration of Conformity Declaration of Conformity No. HH2009080901 No.
RC Terminology Receiver – A device mounted into the vehicle that receives and decodes a signal sent by a transmitter. Servos, ESC and other devices are plugged into the receiver. BEC (Battery Elimination Circuit) – The BEC is used to eliminate the need for a receiver pack to power the radio system. On most electric vehicles this is located in the electronic speed control (ESC), but can also be a standalone device. Resistance – As used here refers to the power loss from the battery to the ESC and motor.
Replacement Parts List Part Number LOSA6215 LOSA6300 LOSA6903 LOSA8200 LOSB0805 LOSB0806 LOSB0818 LOSB2005 LOSB2006 LOSB2007 LOSB2008 LOSB2011 LOSB2015 LOSB2025 LOSB2038 LOSB2039 LOSB2041 LOSB2043 LOSB2044 LOSB2107 LOSB2126 LOSB2164 LOSB2215 LOSB2216 LOSB2218 LOSB2219 LOSB2238 LOSB2241 LOSB2283 LOSB2290 LOSB2356 LOSB2357 LOSB2404 LOSB2405 LOSB2420 LOSB2453 LOSB2735 LOSB2829 LOSB2847 LOSB2902 LOSB2903 LOSB2958 LOSB3001 LOSB3002 LOSB3003 LOSB3004 Description Price #4 Narrow Washers (10) 4-40 Hex nuts Seale
Replacement Parts List (CONT’D) Part Number Description LOSB3005 Slipper Plates LOSB3006 Transmission Main Shaft LOSB3007 Ball Bearing 8 x12 x 3.
Optional Parts for the 1/10 Strike SCT (CONT’D) Part Number LOSA5221 LOSA5222 LOSA5223 LOSA5224 LOSA5225 LOSA5226 LOSA5227 LOSA5228 LOSA5229 LOSA5230 LOSA5231 LOSA5232 LOSA5240 LOSA5241 LOSB2017 LOSB2018 LOSB2040 LOSB2042 LOSB2045 LOSB2109 LOSB2142 LOSB2217 LOSB2404C LOSB2405C LOSB3017 LOSB3527 LOSB7045 LOSB8079 LOSB8081 LOSB8083 LOSB9901 LOSB9902 LOSB9903 LOSB9861 LOSB9862 LOSB9868 LOSB9553 LOSB9555 LOSB9554 LOSB9606 Description Price Silicone Shock Oil, 15Wt, 2 oz Silicone Shock Oil, 20Wt, 2 oz Silicon
LO S SB B235 23 6 56 LO LO LO SB LO LO SB SB 56 30 30 08 SB L 23 56 LO OSB SB 23 57 2 3 LO 56 SB 23 57 LO 23 SB LO 08 LO LO LO LO 56 LO 23 57 56 SB LO LO LO LO SB SB LO SB 23 SB SB 22 23 08 00 LO SB SB 22 15 SB LOS B 24 04 201 1 LO SB 22 83 22 41 20 20 44 25 25 LO SB 23 57 LO SB LO LO SB 07 SB LO 20 LO SB SB 11 SB LO SB 41 LO LO 18 22 38 LOSA8200 56 LO 20 08 LO SB SB LO SB LO LO 06 SB SB 04 08 56 LO 24 SB 23
LO SB 95 22 LO SB 24 53 LO SA LO LO SB SB LO 22 92 SB 62 15 20 21 64 41 LO SB LO SB LO LO SB SB LO SB LO 22 SB 22 18 11 LO SB 24 05 20 16 SB 38 41 20 11 41 LO 07 SB LO SB 22 LO LO 20 15 LO SB LO LO SB 20 19 05 08 20 SB 24 LO SB 41 39 LO SB LO 20 20 20 SB 4 LO 005 SB 20 15 21 07 SB 21 26 LO SB LO SB 35 50 41 07 LO LO SA 69 03 LO SB 35 26 LO S LO B20 15 SB 21 07 SB 35 LO 26 SA 69 0 LO 3 SB 35 2 6 LO SB 2
LOSB4050 LOSB3003 LOSB4120 LOSB4050 LOSB3439 LOSB3010 LOSB3010 LOSB3010 LOSB3003 LOSB3010 LOSB4120 LOSB9498 LOSB3005 LOSB3016 LOSB3005 LOSB3010 LOSB2218 LOSB4050 LOSB3002 * LOSB3551 LOSB3004 LOSB3007 LOSB3004 LOSB3552 LOSB3593 LOSA6903 LOSB3001 LOSA6903 LOSB3006 LOSB3004 LOSB3007 LOSB3002 * LOSB3551 * LOSB3002 (Bearing Holder) Not shown LOSA6903 LOSB3548 LOSB3552 LOSA6903 LOSB2218 LOSA6903 LOSB3001
LOSB7044 LOSB7214 LOSB7214 LOSB2829 LOSB2903 LOSB2903 LOSB2011 LOSB2903 LOSB2011 LOSB2847 LOSB2829 LOSB2903 LOSB2829 LOSB2958 LOSB2903 LOSB2902 LOSB2902 30
Notes: 31
0 Arms Level -2 N/A Losi 30 wt Stock Strike N/A 2 1 B A N/A N/A 1-A 1-Middle 0 (Pivot Block has 2 ) Arms Level -2 Middle N/A Losi 30 wt Stock Strike N/A 3-A 2-Inside Rear 1 Inside Middle Outside 2 1 B 1 2 A OUTSIDE INSIDE 4 3 Losi 550 90 20 34
2 1 B A 1 Inside Middle Outside 2 1 B 1 2 A OUTSIDE INSIDE 35 4 3
™ 1/10-SCALE ELECTRIC SHORT COURSE TRUCK 2010 Losi, A division of Horizon Hobby, Inc. Not responsible for typographical errors. All pricing subject to change without notice. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Spektrum radios and accessories are exclusively available from Horizon Hobby, Inc.
