Owner`s manual

Page 2

Safety Precautions

This is a sophisticated radio controlled model that must be operated with caution and common sense. Failure to operate your

Mini-Rock Crawler in a safe and responsible manner could result in damage to the model and property. The Mini-Rock Crawler

is not intended for use by children without direct adult supervision. Losi and Horizon Hobby shall not be liable for any loss or

damages, whether direct, indirect, special, incidental, or consequential, arising from the use, misuse, or abuse of this product

or any product required to operate it.

• This model is controlled by a radio signal subject to interference from many sources outside your control. This interference

may cause momentary loss of control, so it is advisable to always keep some distance in all directions around your model

as a safety margin to avoid collisions.

• Always operate your model in an open area away from cars, traﬃc and people.

• Avoid running your model in the street where damage can occur.

• Never run your Mini-Rock Crawler with low transmitter batteries.

• Carefully follow the directions and warnings for this and any optional support equipment.

• Keep all chemicals, small parts and anything electrical out of the reach of children.

Tools and Items You Will Find Handy

• Soft bristle brush for cleaning

• 5.5mm nut driver for the wheel nuts.

• #0 or #1 Phillips screwdriver

• .050-inch Allen Wrench (LOSA99100)

Note: Use only Losi tools or other high-quality tools. Use of

inexpensive tools can cause damage to the small screws and

parts used on this type of model.

The Radio System

The following is an overview of the various functions and adjustments found on the Mini-Rock Crawler radio system. Since

the Mini-Rock Crawler operates on a radio signal you control, it is important for you to read and understand about all of these

functions and adjustments before driving.

The Receiver

1. Throttle Port: Where the Electronic Speed Control (ESC) plugs in.

2. Steering Port: Where the steering servo(s) plugs in.

3. Bind Port: Used to “bind” the receiver to the transmitter.

4. Indicator Light: Shows that a frequency/channel is being received.

The Electronic Speed Controller (ESC)

1. On/Oﬀ Switch: Powers the receiver and ESC.

2. Setup Button and Indicator Light: Used for resetting the ESC.

3. Battery Lead: Connects to the battery pack for power.

4. Motor Lead: Connects to the wire leads from the motor.