Owner`s manual

Page 6
Step 1
After removing the shock, push
up on the lower spring cup and
remove it from the shaft. Remove
the spring and preload spacers.
Step 2
Turn the shock upside down
and remove the black shock
cartridge/shaft assembly from
the shock body by turning it
counterclockwise.
Note: If you only wish to change
or fill the shock fluid, skip to
step 5.
Step 3
Remove the top E-clip from the
shock shaft. Remove the shock
piston. Remove second E-clip.
Remove the old cartridge.
Put a drop of oil on the shock
shaft before installing a new
shock cartridge.
Step 4
Reinstall the lower E-clip. Slide
the shock piston onto the shock
shaft against the E-clip. Reinstall
the top E-clip.
Step 5
If you plan on completely
changing the shock fluid
(suggested), dump out the
old fluid from the shock body.
Carefully fill the shock body
with fluid to the bottom of the
threads inside the shock body.
Note: Your Mini-Rock Crawler
comes with 100wt shock fluid
from the factory.
Step 6
Pull the shaft out so the piston is
next to the cartridge and reinstall
the assembly into the shock body,
turn in a clockwise direction until
snug—DO NOT TIGHTEN yet!
Step 7
Turn the shock over and use a #0
Phillips screwdriver to remove the
small bleed screw at the top of
the shock. Slowly push the shock
shaft up until it stops. Excess fluid
should flow out of the bleed hole.
Slowly pull the shock shaft halfway
back and replace the bleed screw.
Use pliers to tighten the cartridge,
being careful not to strip the plastic
lobes on the cartridge.
Step 8
Replace the spring and spring
cup and test the shock action for
smoothness and leaks. Retighten
the bleed screw or cartridge if
either leaks. Remount the shock
on your truck.
Rebuilding/Refilling the Shocks
Service/Repair
Radio/Speed Control and Motor
If you have any problems other than those covered in the troubleshooting section, please call the electronics service
department at [phone]. They will be able to give your specific problem additional attention and instruct you as to what
needs to be done.
Chassis
If you have any questions other than those covered in the troubleshooting or maintenance sections, please call (877) 504-
0233.