Troubleshooting guide

ManualsBrandsLosi Manualsbaby & children1/36 Micro-Desert Truck RTR

Operations Guide

Warning

Although the best materials and components are used, and due to the size of this model,

using anything other than genuine Losi replacement and performance parts specically

designed for the Losi Micro-DT could cause damage.

Customer Service Information:

Horizon Hobby Customer Service

4105 Fieldstone Rd.

Champaign, IL, 61822

1-877-504-0233

www.horizonhobby.com

email: productsupport@horizonhobby.com

Introduction

Thank you for choosing the Micro-DT from Losi. This guide contains the basic instructions for

operating your new Micro-DT. While the Micro-DT is great for rst-time RC drivers, it does require

some mechanical experience and/or parental supervision for drivers under 12 years of age. It is

critical that you read all of the instructions and all accompanying printed material in order to oper-

ate your model correctly and avoid unnecessary damage. Please take a moment to look them

over before running your model.

DO NOT RUN YOUR MICRO-DT ON PLUSH CARPET, GRASS OR SAND.

™

2007 Losi, A Division of Horizon Hobby Inc.

™

Summary of content (8 pages)

PAGE 1
Operations Guide Introduction Thank you for choosing the Micro-DT™ from Losi. This guide contains the basic instructions for operating your new Micro-DT. While the Micro-DT is great for first-time RC drivers, it does require some mechanical experience and/or parental supervision for drivers under 12 years of age. It is critical that you read all of the instructions and all accompanying printed material in order to operate your model correctly and avoid unnecessary damage.
PAGE 2
Safety Precautions This is a sophisticated radio controlled model that must be operated with caution and common sense. Failure to operate your Micro-DT in a safe and responsible manner could result in damage to the model and property. The Micro-DT is not intended for use by children without direct adult supervision.
PAGE 3
The Receiver/Speed Control Receiver/Electronic Speed Control: Receives the signal from the transmitter to control the model’s power and direction of the motor. Receiver Crystal: Determines which channel it will receive. On/Off Switch: Controls power to the receiver. Antenna Wire: Receives the signal from the transmitter. Power Plug: Connects battery pack to the receiver/speed control. Steering Servo: Controls steering movement. Steering Servo Plug: Receiver connection and power supply.
PAGE 4
When adjusted properly, you should be able to hold the rear tires firmly and barely be able to push the spur gear forward with your thumb. To track test, turn the Losi Micro-DT on and place it on the ground. As you push it backwards, allowing it to roll freely, punch the throttle. The slipper should slip no more than an inch or two as it accelerates. Make sure you replace the gear cover before running. Steering Rate Your transmitter is equipped with a steering rate control to the left of the steering wheel.
PAGE 5
chassis. 5) Remove the left side of the gearbox by removing the three screws. 6) Follow Figure 1 below to rebuild the differential (Use LOSA3066 Grease). 7) Once the differential has been rebuilt, assemble the transmission by following the steps in the reverse order. Be sure to use the screws in the same location that they were removed. 1 3 2 1 2 1 1 Figure 1. 3 Changing the Spur Gear Remove the gear cover by removing the three small screws.
PAGE 6
Replacing the Steering Servo 1. Unplug all wires, remove receiver crystal and 4 screws pictured in Figure 1. (Be sure to note the locations of all screws and sizes.) 2. Remove the 2 screws pictured in Figure 2. and place the PC board to the side. 3. Remove the 4 screws pictured in Figure 3. Remove the servo cover. 4. Slide the servo out from the chassis as shown in Figure 4. 5. Replace with new servo and be sure to place the tip of the servo saver into the slot of the steering bellcrank. 6.
PAGE 7
SERVICE/REPAIR If you have any problems other than those covered in the troubleshooting section of this operation guide, please call the Horizon Hobby Customer Service line at 1-877-504-0233. They will be able to give you specific additional attention and instruct you as to what needs to be done. Horizon Hobby Customer Service 4105 Fieldstone Rd. Champaign, IL, 61822 1-877-504-0233 www.horizonhobby.com email: productsupport@horizonhobby.com Warranty Period: Exclusive Warranty- Horizon Hobby, Inc.
PAGE 8
Safety Precautions: This is a sophisticated hobby Product and not a toy. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the Product or other property. This Product is not intended for use by children without direct adult supervision. The Product manual contains instructions for safety, operation and maintenance.