User Manual

EN
9
LOSI 8IGHT/8IGHT-T RTR • INSTRUCTION MANUAL
Binding and Calibrating the Receiver
Changing the Travel Adjust Settings
Maintenance and Troubleshooting
1. Insert the bind plug into the bind port on receiver.
2. Power on the receiver, the LED will flash rapidly to indicate it is in bind mode.
3. Power on the transmitter; the LED light on the receiver will stop flashing an stay
illuminated to indicate binding is complete.
Always set the failsafe position for zero throttle.
1. Power on the TX and RX ,make sure the transmitter and receiver are connected
properly.
2. Hold steering, throttle trigger and AUX controls at the desired failsafe positions.
3. Insert the bind plug into the bind port on the receiver; The LED on the receiver
will flash 3 times and then remain lit to indicate the failsafe positions have been
set.
Adjusting Steering and Throttle Trims
Steering Trim
The model should go straight without turning the steering wheel. If not,
turn the ST TRIM knob in the direction needed for the model to go straight.
STATUS
ST
TH
S/R
STATUS
ST
TH
S/R
The servo travel on the Steering and Throttle channels can be adjusted through a
special programming mode in the transmitter.
1. Begin with the transmitter binding process to the receiver complete. Power ON
the receiver.
2. Hold full right and full brake while powering the transmitter ON to put the
transmitter into programming mode.
The LED on the transmitter will flash 4 times to indicate it is in programming mode.
3. Turn and hold the wheel full left to set the travel limit for that direction, Press the
A button to increase travel, press the B button to reduce travel. The LED will flash
once with every change. Return the wheel to center to set the travel value.
IMPORTANT: If the value has reached the maximum or minimum that can be
accepted, the LED will not flash with further input.
4. Turn the wheel to the right and repeat the process to set the steering travel to
the right.
5. For electric vehicles, power the Transmitter OFF to save the settings. Calibrate
your ESC to the default throttle travel.
6. For fuel powered vehicles, set the throttle travel without the engine running. After
setting steering travel, you can set throttle travel with the same process. Pull and
hold full throttle, adjust travel with the A and B buttons, return to center to set
the value.
7. Push full brake, adjust travel with the A and B buttons, return to center
8. Power the transmitter OFF to save the values.
Failsafe