Getting Started Guide Owner manual

Page 2

Operations Check

Throttle

Steering

Throttle/Brake

Linkage

Turn on the transmitter and check for proper voltage (fig. 4A).

Slide the switch on the side of the radio box to the "ON" position.

With the front tires off of the ground (fig. 4B), turn the steering

wheel on the transmitter from left to right. The wheels should turn

smoothly and with ease. Also operate the throttle and brake

(fig. 4C), checking for quick, smooth operation. Do not try to

operate your truck if any of the servos or any part of the radio is not

operating correctly. If the servos operate slowly, the batteries are low

and must be replaced (if using alkaline batteries) or recharged. Never

try to operate your model if either the transmitter or receiver batteries

are low.

After filling the fuel bottle with fuel, lift the lid of the fuel tank and fill the tank (fig. 5A). Make sure you put the lid back on both

the fuel bottle and the jug of fuel. Press down on the primer button several times (fig.5B) until you see the fuel move through

the fuel line to the carburetor. Do not pump the primer after the fuel reaches the carburetor or you will flood the engine and

make it difficult to start.

Fueling

5A 5B