User Manual Manual

Page 8
Servicing the Differentials
The differentails should be serviced periodically. Be sure to clean and inspect all of the gears and
replace if severely worn. Always use plenty of high-quality grease (like Team Losi LOSA3066)on all
gears. NOTE: These can also be made into racing type viscous diffs as noted below. Always service
one diff at a time and pay close attention to install the housing with the "TOP" marking up so it
can be seen looking down on the truck.
IMPORTANT:
Always reinstall
the thin gasket.
For Viscous Differential
Instead of grease you can use Silicone fluid in the differential
for a limited slip feel as desired for racing. Simply fill the diff
up to the top of the gears before replacing the ring gear.
(Be sure to reinstall the gasket). You may have to replace the
o-rings on the outdrives at the same time you change to this type
of differential if the old ones are worn. Popular silicone fluid
for monster trucks is 10,000cs and is available at your local hobby
dealer.
Fig 1.
Fig 2.
Fig 3.
Removing the diffs
Remove the two screws in the bottom at the extreme end of the chassis (fig1)
Remove the four screws in the bulkhead allowing the bumper/skidplates and pin mounts to be removed (fig 2).
Remove the diff retainers and slide the diff out (fig 3). NOTE: On the front end only you will have to remove the lower
front shock attachment screws and swing the shocks up and out of the way. On the rear end you will need to "pop" off the
rear camber links.
Diff Service
Remove the three 5/64" cap head screws and the top of the differential housing, then the diff.
Remove the four 5/64" flat head screws from the ring gear allowing it to be removed.
Inspect the ring and pinion gears for wear - replace if necessary.
Remove the cross shafts, bevel gears, and shims for the carrier.
Clean and inspect all parts - replace as needed.
Check all ball bearings. Clean or replace as necessary.
Remove pins from outdrives. Remove outdrives, regrease and reinstall.
Lube all shafts and gears with LOSA3066 assembly grease and reassemble.
Load cross shafts with gears into the carrier with extra grease. Apply the rubber
gasket to the carrier and reinstall ring gear.
Lube ring and pinion with grease and reassemble diff into diff housing.
Reinstall into chassis with "TOP" on housing facing up.