Getting Started Guide Owner's manual

ManualsBrandsLosi ManualsToysLOSB0084

Page 1

Radio Batteries

Install the 4 AA-size alkaline batteries (included) in

the transmitter making sure the positive (+) and (-)

negative ends are oriented correctly.

GETTING STARTED

Before you start running your LOSI

8IGHT 2.0

™

RTR read your

engine break-in and operating instructions. If you run your 8IGHT

2.0 RTR without following proper break-in procedure, you may

damage or fail to get maximum performance from your engine,

and void the warranty.

NOTE:

Receiver Battery

Unscrew the two 4-40 screws and remove the two

body clips from the battery box on your 8IGHT 2.0 RTR.

Here you will ﬁnd your receiver battery pack. By using

the charger of your choice, follow the manufacturers

instructions and charge the receiver battery pack (ﬁg.

2A). After the pack has been charged plug the battery

into the switch harness (ﬁg. 2B).

Fig 1

Fig 2A

Fig 2B

Summary of content (4 pages)

PAGE 1
GETTING STARTED NOTE: Before you start running your LOSI® 8IGHT 2.0™ RTR read your engine break-in and operating instructions. If you run your 8IGHT 2.0 RTR without following proper break-in procedure, you may damage or fail to get maximum performance from your engine, and void the warranty. Radio Batteries Receiver Battery Fig 1 Install the 4 AA-size alkaline batteries (included) in the transmitter making sure the positive (+) and (-) negative ends are oriented correctly.
PAGE 2
Starter Box Battery Installation Remove these two screws to open the starter box Fig 3A You will need to purchase two 7.2V 6-cell battery packs for the Starter Box. Losi recommends using (2) LOSB9900 7.2V 3600mAh 6-cell NiMH Performance Spec Battery Packs. By using the charger of your choice follow the manufacturers’ directions to charge both batteries. Once both batteries are charged, they will need to be inserted and secured inside of the starter box.
PAGE 3
Operations Check Steering Throttle Brake Right Left Fig 4D Fig 4A Throttle Brake Turn on the transmitter and check for proper voltage. On the vehicle, slide the switch on the side of the radio box to the “ON” position (fig 4B). With the front tires off the ground, turn the steering wheel on the transmitter from left to right (fig. 4A). The wheels should turn smoothly and with ease (fig. 4c). Also operate the throttle and brake (fig. 4d), checking for quick, smooth operation.
PAGE 4
Start Your Engine Stopping the Engine With the vehicle sitting on the starter box, attach the glow plug igniter (fig. 6A) to the glow plug. Push down on the glow igniter to start the contact of the starter box to the flywheel of the engine (Fig 6B.) If the engine does not turn over, it is probably flooded or the batteries in the starter box need to be recharged.