Getting Started Guide Owner's manual

Printed 03/09
800-0388
Page 4
Stopping the Engine
To stop the engine, use the handle of a screwdriver
or a rag to cover the exhaust pipe exit (fig. ), being
EXTREMELY careful not to burn your hand as this will
be hot.
Start Your Engine
With the vehicle sitting on the starter box, attach
the glow plug igniter (fig. 6A) to the glow plug. Push
down on the glow igniter to start the contact of the
starter box to the flywheel of the engine (Fig 6B.) If the
engine does not turn over, it is probably flooded or the
batteries in the starter box need to be recharged. If you
suspect flooding, use a glow plug wrench to loosen
the glow plug at least two turns and press the vehicle
down to engage the starter box and contact with the
fly wheel again. Raw fuel should come out around
the plug. Tighten the plug and resume the starting
procedure.
Follow the engine break-in procedure before
attempting any racing or high-performance operation.
Use caution when adding fuel while the engine is
running. Do not over-fill or spill fuel outside the tank.
Fig 6A
Fig 6B