User guide

4
XXX-SCT ELECTRONICS SYSTEM OVERVIEW
BIND PLUG
ON/OFF SWITCH
LOSI MSC12L
STEERING SERVO
SETUP BUTTON
EC3
™
BATTERY PLUG
LOSI MOTOR
SPEKTRUM SPMSR300
PEAK DETECTION CHARGER
Peak detection chargers monitor the battery during charging and
automatically shut off upon full charge. You can either purchase a peak
detection charger that plugs into a household AC wall socket or one
that requires you to also purchase a 12V power supply.
LOSB9602
If using a charger other than a peak detection charger, make sure your
battery is fully discharged prior to charging. Many of these have a
15–20 minute timer that allows you to set a charge time. If the battery
is not fully discharged, you can potentially over-charge your battery
pack. Do not charge any battery unattended, and monitor for heat
build up. If the battery pack is more than warm to the touch, immedi-
ately discontinue charging. Read all safety precautions supplied by the
charger and battery manufacturer.
SUPPLIED AND REQUIRED EQUIPMENT
Supplied tools
2-Waywrench  •Transmitter/ReceiverBINDPlug•
4HexWrench“L”shaped •.050,1/16,5/64,and3/32•
FlatTurnbuckleWrench •4AAAlkalineBatteries•
Recommended Accessories
Hobbygradeknife  •Needlenosepliers•
Sidecuttingpliers  •Safetygoggles•
Solderingiron  •Double-sidedtape(LOSA4004)•
CA glue (LOSA7880 or LOSA7881)•
Required Equipment
A 6- to 7-cell NiMH battery pack. Or with proper knowledge, LiPo •
battery packs.
NiMH battery charger with automatic peak detection •
recommended (LiPo charger if using LiPo battery).