EN DE FR IT Not responsible for errors. All prices subject to change without notice.
Notice Introduction All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. Thank you for choosing the TEN-SCTE. We are confident you will be satisfied with the performance of this durable and resilient vehicle. Please read through the entire manual before setting up and using your vehicle.
Batteries and Charging Peak Detection Charger The TEN-SCTE uses rechargeable batteries such as NiMH. These batteries all have special requirements to preserve performance and last. • Read all instructions provided by the manufacturer of the batteries. • Never allow minors to charge battery packs. • Always check to ensure the polarity of battery connection is correct. • Never leave batteries unattended while charging. • Never charge a battery while it is installed in the TEN-SCTE.
The Losi TEN-SCTE Overview Rear Shock Sway Bar Rear Camber Link Rear Suspension Arm ESC with Fan (not included) Motor (not included) Center Differential Battery Tray Receiver Location Steering Servo (not included) Tie Rod Front Suspension Arm Front Shock Front Camber Link Sway Bar 4 - EN
Tools You Will Find Handy Basic Electronics Installation Instructions Caution: Please be sure to follow the electronics manufacturers guidelines when installing and setting up your radio, motor, servo, electronic speed control, and battery. Motor Installation: Follow diagram below 1. 2. 3. Install motor adapter onto motor with two supplied M3x10mm screws. Install pinion gear (recommendations supplied earlier).
Before Running Your TEN-SCTE 1. 2. 3. 4. 5. 6. 7. 8. 9. Break in the differentials. While holding the chassis with only the left side tires firmly on the ground, give the car about one eighth throttle, for 30 seconds. The right side tires should spin freely during this time. Repeat this with only the right side tires firmly on the ground, allowing the left side tires to spin freely. Repeat this 2–3 times. Check for free suspension movement.
Tuning, Adjusting and Maintaining the TEN-SCTE Periodically examine your TEN-SCTE for the following: • Keep your vehicle clean using a brush to remove dirt and dust. • Look for cracks in the suspension arms and other molded parts. • Check that the tires are still glued to the wheels. • Check that all the wheel bearings are clean and lubricated. • Using your tools, attempt to tighten all the screws and nuts. • Verify that the Camber Links and Steering linkage are not bent.
Maintenance Tuning the Front End of the TEN-SCTE Shock Location: The TEN-SCTE has three mounting locations on the front shock tower. The position can be easily adjusted by simply moving the top of the shock to another hole. The standard location works best on most surfaces. Moving the top of the shock inward a hole will slow steering response and make the TEN-SCTE smoother in bumps. The standard position on the arm is middle, which offers the best balance.
Inboard Camber Location: The TEN-SCTE has two different inner locations with vertical adjustment for the front camber tie rod. In general, the lower or further out the inside position is, relative to the outside, the more camber gain (total camber change through the total throw of the suspension) is present. This is an adjustment that is difficult to make a generic statement as it can have slightly different results in various conditions.
Use the same technique to adjust the rear ride height. Again, refer to the included setup sheet. Every driver likes a little different feel so you should try small ride height adjustment to obtain the feel you like. This should be the last adjustments you make after everything else is dialed in. Note: Do not use ride height adjustments as a substitute for a spring rate change. If your TEN-SCTE needs a softer or firmer spring, change the spring.
Warranty and Repair Policy Warranty Period Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase by the Purchaser. Limited Warranty Horizon reserves the right to change or modify this warranty without notice and disclaims all other warranties, express or implied. (a) This warranty is limited to the original Purchaser (“Purchaser”) and is not transferable.
United States Warranty Services (Electronics and engines) Horizon Service Center 4105 Fieldstone Rd Champaign, Illinois 61822 USA 877-504-0233 Questions, Assistance, and Repairs Your local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or use of the Product has been started, you must contact Horizon directly. This will enable Horizon to better answer your questions and service you in the event that you may need any assistance.
REPLACEMENT PARTS LIST Part Number LOSB2021 LOSB2022 LOSB2023 LOSB2100 LOSB2103 LOSB2123 LOSB2124 LOSB2163 LOSB2170 LOSB2211 LOSB2213 LOSB2222 LOSB2278 LOSB2279 LOSB2359 LOSB2411 LOSB2412 LOSB2413 LOSB2414 LOSB2415 LOSB2416 LOSB2417 LOSB2418 LOSB2419 LOSB2421 LOSB2825 LOSB2826 LOSB2845 LOSB2904 LOSB2905 LOSB2906 LOSB2961 LOSB3104 LOSB3436 LOSB3495 LOSB3536 LOSB3542 LOSB3553 LOSB3555 LOSB3556 LOSB3563 LOSB3564 LOSB3565 LOSB3568 LOSB3569 LOSB3571 Description Front Suspension Arm Set: 10-T Rear Suspension Mou
OPTIONAL PARTS LIST Part Number LOSA5224 LOSA5225 LOSA5226 LOSA99004 LOSA99006 LOSA99013 LOSA99015 LOSA99104 LOSA99165 LOSA99772 LOSA99173 LOSA99174 LOSA99202 LOSA99203 LOSA99217 Description Certified Shock Fluid 30 wt. Certified Shock Fluid 35 wt. Certified Shock Fluid 40 wt.
Ten-SCTE x 10/06/10 x x x x 1 degrees OUT 29.5mm 0 degree Stock/20 degrees 2.0mm 4 holes @ 1.07mm/40 wt Gold/Hard 3 2 1 Inside Center Outside 1 2 85mm Center to Center Long Up Position 1 Position 1 / Outside Grease For increased stability, use 10000 weight oil in the front and center differentials. Grease 3 degrees 2 degrees 24.5mm -2.5 degrees All the way back 1.8mm 4 holes @ 1.09mm/30 wt Black/Medium 1 2 3 B A Inside Center Outside 1 2 100.
A6271 B2170 B2414 A6286 A6295 B3572 A8200 A6236 B2417 B2022 B2213 A6279 A6272 B2222 B4023 B4022 A6957 B4003 A6302 B4109 B3564 A6302 A6256 A6278 B3564 B3104 B4023 B4022 A6302 A6229 A6279 B4109 A6282 A6278 B3104 A6947 B2211 A6302 REAR EXPLODED VIEW HECK EXPLOSIONSZEICHNUNG VUE ÉCLATÉE ARRIÈRE VISTA ESPLOSA DELLA PARTE POSTERIORE A6947 B2278 B2213 B3578 B3578 A6302 B2023 A6302 B3553 B2103 A6279 B3570 A6278 B2417 B3542 A6956 A6958 B3495 B3546 B3542 A6278 B2414 B3569
A6956 B3571 Front B3542 B3563 B3542 B3563 B3568 B3563 B3563 B3568 B3542 B3572 Rear B3542 B3568 B3563 B3569 B3563 B3568 A6277 B2421 A6240 A6275 B2163 A6240 A6302 A6229 B2906 A6302 B2421 A6278 A6272 A6227 B2211 B2213 B2414 A6256 A6286 B2222 B2021 B4109 A6286 A6236 B2278 A6947 A6302 A6275 B3555 B3556 B2211 B2213 A6302 B4023 B4003 B3495 B2100 A6958 A6272 B4022 B2100 B2100 B3574 A6275 B4022 B3564 B4109 A6957 B2100 A6302 A6947 B3564 A6282 A8200 FRONT EXPLODED VIEW FRON
B4022 B4003 A6270 B2124 B2124 A6907 B2123 A6275 B2123 B2124 A6907 B2278 CHASSIS EXPLODED VIEW CHASSIS EXPLOSIONSZEICHNUNG VUE ÉCLATÉE DU CHÂSSIS VISTA ESPLOSA DEL TELAIO B2419 B4023 B2279 B2279 B2279 B2411 A6271 A6277 A6278 A6256 B2123 A6907 A4210 B4210 A6907 B2124 A6302 B4023 A6306 A6275 B4022 A6271 A6270 B3553 B3542 A6956 B3568 A6306 B4210 B4210 A6256 A6302 A2278 B3570 B3542 B3436 B3553 B3568 B3542 A6270 B3542 B3553 B2419 B3569 B3542 B3568 B3553 B3542 B3542 A6956 B35
B2904 B2904 B2359 B2906 B2906 A6229 B2960 Soft B2359 B2961 Medium B2961 Medium A4006 B4210 B2962 Firm B2960 Soft B2845 B2825 A6204 B2906 A6350 B2904 B2962 Firm B2845 B2826 B2906 B2904 B2360 B2905 B2905 B2359 B2904 B2359 B2904 B2904 A6271 B2416 B2412 A6277 A6267 A6240 B2415 B2413 B3592 61 B2904
A7215 A6258 B7018 B7109 A6315 A6240 B2421 A6264 62
©2010 Horizon Hobby, Inc. Not responsible for typographical errors. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Losi, Xcelorin and MultiPro are trademarks or registered trademarks of Horizon Hobby, Inc. Airtronics® is a registered mark of Sanwa Electronic Instrument Co., Ltd., Osaka, Japan. Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan KO PROPO® is a registered trademark of Kondo Kagaku Co., Ltd., Tokyo, Japan.
