User Manual

7 - EN

7 -

Tuning, Adjusting and Maintaining the TEN-SCTE

Periodically examine your TEN-SCTE for the following:

• Keep your vehicle clean using a brush to remove dirt

and dust.

• Look for cracks in the suspension arms and other

molded parts.

• Check that the tires are still glued to the wheels.

• Check that all the wheel bearings are clean and lubricated.

• Using your tools, attempt to tighten all the screws and

nuts.

• Verify that the Camber Links and Steering linkage are

not bent.

• Check that the Toe and Camber settings are as desired

and equal.

• Check the Drivetrain:

o Check the Spur gear for wear.

o Check the Pinion gear.

• Take the shocks o the vehicle and check, especially if they

appear to be leaking as it is time to rebuild them.

• Look over all the wiring and connections for bare wire or

any place which could lead to a short circuit.

After you become familiar with driving your TEN-SCTE,

you may need to reset or make adjustments for better

driving performance.

Just as in a real car, alignment is an important factor in your

vehicle’s handling. When you are ready to make adjustments

it is a good idea to have a  at work space to place your vehicle

on. This will enable you to easily and more quickly make both

Toe-in and Camber adjustments. These adjustments should be

set with the vehicle sitting at its normal ride height.

Three-Position Battery Tray: Your TEN-SCTE comes with

a three-position battery tray to alleviate the need for foam

blocks. You can move the included battery stops in order to run

the battery in a back, middle, or forward position. Please see

pictures as follows.

BACK

MIDDLE

FORWARD