Product manual

ManualsBrandsLosi Manualsbaby & childrenLOSB0230T2

Operations Guide

Warning

Althought the best materials and components are used, and due to the size of this model,

using anything other than genuine Team Losi replacement and performance parts spe-

cically designed for the Micro-T could cause damage. The use of Li-Po batteries, more

powerful motors, or unapproved parts could cause drivetrain and chassis failure voiding

any warranty either written or implied.

Customer Service Information:

Horizon Hobby Customer Service

4105 Fieldstone Rd.

Champaign, IL, 61822

1-877-504-0233

www.horizonhobby.com

email: productsupport@horizonhobby.com

Introduction

Thank you for choosing the Micro-T™ from Team Losi ®. This guide contains the basic instruc-

tions for operating your new Micro-T. While the Micro-T is great for rst-time R/C drivers, it does

require some mechanical experience and/or parental supervision for drivers under 12 years of

age. It is critical that you read all of the instructions and all accompanying printed material in

order to operate your model correctly and avoid unnecessary damage. Please take a moment to

look them over before running your model.

DO NOT RUN YOUR MICRO-T IN PLUSH CARPET, GRASS OR SAND.

Summary of content (5 pages)

PAGE 1
Operations Guide Introduction Thank you for choosing the Micro-T™ from Team Losi ®. This guide contains the basic instructions for operating your new Micro-T. While the Micro-T is great for first-time R/C drivers, it does require some mechanical experience and/or parental supervision for drivers under 12 years of age. It is critical that you read all of the instructions and all accompanying printed material in order to operate your model correctly and avoid unnecessary damage.
PAGE 2
Safety Precautions This is a sophisticated radio controlled model that must be operated with caution and common sense. Failure to operate your Micro-T in a safe and responsible manner could result in damage to the model and property. The Micro-T is not intended for use by children without direct adult supervision.
PAGE 3
chassis. 5) Remove the left side of the gearbox by removing the three screws. 6) Follow Figure 1 below to rebuild the differential (Use LOSA3066 Grease). 7) Once the differential has been rebuilt, assemble the transmission by following the steps in the reverse order. Be sure to use the screws in the same location that they were removed. When adjusted properly, you should be able to hold the rear tires firmly and barely be able to push the spur gear forward with your thumb.
PAGE 4
Replacing the Steering Servo 1. Unplug all wires, remove receiver crystal and 4 screws pictured in Figure 1. (be sure to note the locations of all screws and sizes). 2. Remove the 2 screws pictured in Figure 2. and place the PC board to the side. 3. Remove the 4 screws pictured in Figure 3. Remove Servo Cover. 4. Slide the servo out from the chassis Figure 4. 5. Replace with new servo and be sure to place the tip of the servo saver into the slot of the steering bellcrank. 6.
PAGE 5
Safety Precautions: This is a sophisticated hobby Product and not a toy. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the Product or other property. This Product is not intended for use by children without direct adult supervision. The Product manual contains instructions for safety, operation and maintenance.