User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
CODELOG MODE
Chapter overview
Guide to the SRX 600 receiver Rev A #10112 Chapter 5 - - Page 44
5
• Enable/Disable GPS Positioning
• Provide a Site Number
3)Freq/CH
• Add a Radio Frequency and Channel
• Add an Acoustic Frequency and Channel
• Modify settings for a single Frequencies
• Modify settings for all Frequencies
4)Ant/Hydr
• Select the ASP-8 antenna switchbox
• Add antennas to the Radio Antenna Group
• Add hydrophones to the Hydrophone Group
• Designate a Radio Antenna Master
• Designate a Hydrophone Master
• Assign a gain value to the ASP-8
• Assign a gain value to the AH0 antenna/hydrophone
• Assign a gain value to the Radio Master Antenna
• Assign a gain value to the Hydrophone Master
• Select Frequency or Antenna Priority
• Enable/Disable Master Antenna Preview
5)Filters
• Assign a Filter Type for data collection
• Accept or Reject a Channel and ID combination
• Accept or Reject a transmitter ID
• Set an Echo Filter for detections
• Set a Noise Threshold for detections
• Enable/Disable the minimum Pulse Width (2ms) for detections