User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
. . . . .
CODELOG MODE
1)Config## > 4)Ant/Hydr
Guide to the SRX 600 receiver Rev A #10112 Chapter 5 - - Page 61
A SSIGNING A HYDROPHONE MASTER
Assign a hydrophone to be the master hydrophone via Codelog > 1)Config## >
4)Ant/Hydr > 4)Hydr > 2)Acoustic Master Hydr. There are three possible
selections:
• Enter the value as 0 (zero) to make all hydrophones masters
• Enter a value from 1 through 8 to make a single hydrophone the master. The
value entered corresponds to an antenna port number on the ASP-8
• Enter the value as 9 to designate NO hydrophone as master
After a value has been entered the receiver returns to the page of menu selections.
A SSIGNING GAIN VALUES
The ASP-8 and all antennas must be assigned gain values. A typical starting gain
value is 50, but should be set according to the requirements of the study.
A SSIGNING GAIN VALUES TO ANTENNA PORTS ON THE
ASP-8
Assign gain values to each of the Antenna Ports on the ASP-8 via Codelog >
1)Config## > 4)Ant/Hydr > 4)Gain > 1)ASP-8 Gain. Enter the number of the
antenna port to provide a gain value for. The display then updates to prompt for a
gain value. Immediately after the appropriate gain value has been entered the
display returns to the ASP8 Gain page. After the ASP8 Gain title in the display is a
series of numbers in brackets. These numbers are the current gain value settings
corresponding to an antenna port. They are listed in order from 1 to 8.
A SSIGNING A GAIN VALUE TO THE ANTENNA PORT ON
THE FRONTPANEL
Assign gain values to each antenna via Codelog > 1)Config## > 4)Ant/Hydr >
4)Gain > 2)AH0 Gain.