User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
. . . . .
CODELOG MODE
1)Config## > 5)Filters
Guide to the SRX 600 receiver Rev A #10112 Chapter 5 - - Page 71
The maximum signal strength deviation is 18. Enable or disable this feature via
Codelog > 1)Config > 5)Filters > 2)Pulse Filter > 4)Signal Strength Dev >
1)Enable or 2)Disable. The display shows the current setting in brackets using the
number of the menu items available. For example, if signal strength deviation is
disabled then the number in brackets is 2.