User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
. . . . .
CODELOG MODE
2)Scan > 1)Continue to log data
Guide to the SRX 600 receiver Rev A #10112 Chapter 5 - - Page 75
2)SCAN > 1)CONTINUE TO LOG DATA
The settings available under this menu item are as follows:
• Start a scan
• Delete all data from the receiver
S TARTING A SCAN CYCLE
A scan cycle is initiated via Codelog > 2)Scan > 1)Continue to Log Data. Once a
scan is started no changes can be made to the active configuration, except when
the scan is paused. The only actions that can be taken at this point are the
following:
A DJUSTING FREQUENCY AND GAIN
Go to the next/previous applicable frequency in the frequency table
used by the active configuration using the Up or Down Arrows.
A new gain can be selected using the Up or Down Arrows. The
amount of increment or decrement is specified by Set Delta for gain
(see section called Set Delta in chapter 1 for details).
P AUSING A SCAN
Accessed via Codelog > 2)Scan > 1)Continue to Log Data > 0)Pause Scan. This
function suspends the scan cycle on the frequency and antenna that was being
scanned when pause was selected. The receiver does not change the frequency or
antenna it was scanning when pause was selected, but it does continue logging
data for that frequency and antenna.
Any settings changed while paused are only applied to the frequency and
antenna that the receiver was scanning when pause was selected.