User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
CODELOG MODE
2)Scan > 2)Del All Data (password)
Guide to the SRX 600 receiver Rev A #10112 Chapter 5 - - Page 78
5
2)SCAN > 2)DEL ALL DATA (PASSWORD)
D ELETING ALL DATA IN THE RECEIVER
Data cannot be deleted from the receiver unless the password is provided. As
soon as a password is provided the receiver deletes all data. There is no warning
prior to deletion.
3)MASTER FTABLE
The settings available under this menu item are as follows:
• Enter in the frequency to be used by any UUCs (ultrasonic upconverter)
connected to the ASP-8
• View frequencies in the Master Frequency Table
E NTERING A UUC FREQUENCY
Enter a the frequency in MHz for the UUC via Codelog > 3)MasterFtable >
1)UUC Freq. This frequency can be in the range of 148.000 to 152.000 MHz.
V IEWING THE MASTER FREQUENCY TABLE
All frequencies in all frequency tables are copied into a master list called the
Master Frequency Table. View this list via Codelog > 3)MasterFtable > 2)View
Master Ftable. Use the Right and Left Arrow keys to move forward and
backward through the list. The display provides the frequency and channel, as
well as which Configuration(s) uses that frequency+channel.