User Guide
Table Of Contents
- Welcome to the SRX 600
- CONTENTS
- Hardware details
- 1
- 2
- 3
- 4
- Chapter Overview
- 1)Code Set (and details on codes)
- 2)Search
- 3)Signal
- Codelog Mode
- 5
- Chapter overview
- 1)Config > 1)NewCFG
- 1)Config## > 2)Scan Settings
- 1)Config## > 3)Freq/Ch
- Creating a Configuration Specific Frequency Table
- Adding a Frequency/channel
- Deleting a Frequency/channel
- Enabling and Disabling a Frequency/channel
- Assigning a Transmitter Type to a Freq/Ch
- Deleting all frequencies in a Frequency Table
- Enabling/Disabling all frequencies in a Frequency Table
- Assigning a Transmitter Type to all Freq/Ch
- 1)Config## > 4)Ant/Hydr
- 1)Config## > 5)Filters
- 1)Config## > 6)Sensors
- 2)Scan > 1)Continue to log data
- 2)Scan > 2)Del All Data (password)
- 3)Master Ftable
- Downloading Data
- 6
- 7
. . . . .
APPENDICES
Appendix A: Understanding the Format of Data Records
Guide to the SRX 600 receiver Rev A #10112 Chapter 7 - - Page 81
• What the total scan time value is
• The scan time set for the frequencies
• Whether CRTO is enabled or disabled
• Whether AGC is enabled or disabled
• The Echo Filter time
• The code set being used
When the receiver begins collecting data a complete environment record is stored
in the memory with a time stamp. After that only changes to the settings are
stored with a time-stamp indicating when the change took affect.