User's Manual

Guide to the SRX800 Receiver Preliminary
3)SI G N AL
ST A R T I N G A SC A N V I A SI G N AL
Scanning using Signal means that the receiver monitors only one frequency and
one antenna until they are changed manually. The scan cannot be paused using
Signal.
Start a scan via:
Manual > 3)Signal > 1)Start
SE L E C TI N G A CO D E SET
Codes sets are accessed via:
Manual > 3)Signal > 1)Start > 1)Code Set
Use the keypad to select the desired code set. If the receiver is offline, then
accessing the code set feature only provides current setting information.
SE T T I N G T H E TY P E O F TR AN S M I T T E R T O SC AN
This is a toggle-type control. Set the type of transmitter to scan via:
Manual > 3)Signal > 1)Start > 2) Show Beep/ID/Sensor
The type selected depends on the type that was selected previously. For example,
if the scan was showing sensor (SEN) type transmitters, then pressing 2)Show
Beep/ID/Sensor once causes the type to change to Beep. Pressing 2)Show
Beep/ID/Sensor again switches the type to ID and so on.
No indication is given that the type of transmitter to scan has been changed.
Press the Left Arrow key once to go back to the first menu page to see that the
type has been changed.