User's Manual

SE T DE L T A F O R FR E Q U E N C Y
When adjusting the frequency manually, the receiver increases or decreases the
frequency (kHz) in use by an amount equal to the Frequency Delta increment.
Set this increment via: Manual > 3)Signal > 1)Start > 3)Set Delta > 1)Freq
SE T DE L T A F O R GA I N
When incrementing gain manually, the receiver increases the gain in use by an
amount equal to the Set Delta gain increment.
Set this increment via: Manual > 3)Signal > 1)Start > 3)Set Delta > 2)Gain
ST A R T I N G A GPS AC Q U I S I T I O N
Start acquiring a GPS 2D position by pressing the GPS key on the keypad (key
number 4). While attempting to acquire a position, the display shows the number
of satellites as they are found.
If a valid position is acquired, the following information is provided in the
display: Latitude, Longitude, current date, current GMT time, the number of
satellites used, HDOP, and PDOP. The display flips back and forth between
showing the Latitude and Longitude for four seconds and the satellites, HDOP,
and PDOP information for two seconds. Either the time or the date is also shown
on the display and is updated every five seconds.
GPS cannot be used if the receiver is logged off. However, it is possible to log
off from the receiver while the receiver is attempting to acquire a GPS position.
When logging back on, the display shows the results of the GPS position.
Press the END/ESC key to stop acquiring a GPS position.