User's Manual

Guide to the SRX800 Receiver Preliminary
RE C E I V E R CA R E , MA I N T E N A N C E A N D SE R V I C E
 Protect the SRX800 from excessive dust and moisture. If basic cleaning is
required, wipe the housing and front panel gently with a soft cloth. To
clean it more thoroughly, wipe the housing with a soft cloth dampened
with a mild solution of soap and water. Do not allow any liquid to get
inside the housing. Store the unit in a cool dry place when not in use.
 Always use the head-phones provided by Lotek (stereo plug, 30 Ohm
speakers). Upon inserting the plug, the audio signal will be disconnected
from the main speaker, and routed through the head-phone speakers.
 Always use the GPS antenna provided by Lotek (3 V active antenna)
 Always use the external AC to DC wall power supply provided by Lotek.
Do not use other power supplies, even if they provide the correct 9 V DC
voltage! Check the LED on the rear panel: The LED should be green. If
the LED is red, the receiver will not be energized, as most probably the
improper AC-Dc is used.
 Turn off receiver when removing or replacing batteries
 Insert batteries with the correct polarity.
 Replace all batteries at the same time. Do not mix used and new batteries.
Use only batteries from known reliable suppliers (e.g. Energizer,
Panasonic, Duracell, etc.). Dispose used batteries in concordance with the
applicable laws. Do not put them in the normal waste.
 IMPORTANT: Do not open the receiver. The device is not supposed to be
serviced or repaired by users. It will be exclusively serviced by Lotek
qualified technicians. In case of malfunction, contact Lotek, and
arrangements will be made for sending the receiver back and having it
serviced.
 Warning: Do not use the telemetry receiver outside the specified conditions
stated by the manufacturer. The improper usage of the device may cause
performance alteration or damage. If this happens, contact Lotek for
service. See the warning symbol attached to the rear panel (see